HUSKY LINERS 6141 Manual

6141 front and back-1.doc
03/07/06
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liners are custom molded to fit your particular vehicle. The liners are made to take the place of
your factory floor mats. For correct fit, it is necessary to remove the factory floor mats before installing your new
floor liners. However, do not remove the factory-installed carpeting.
Your liners are made from an engineering resin that is lightweight and extremely tough and durable. The easiest
way to clean your liners is with a damp cloth or sponge. If using a cleaner, 409®or Glass Plus®work well. Use of
Armor All®, Son-of-a-Gun®or similar items is discouraged as these products make the liners slick.
INSTALLATION INSTRUCTIONS FOR YOUR CHEVROLET TAHOE/ GMC
YUKON/CADILLAC ESCALADE SECOND SEAT FLOOR LINERS
IF YOUR VEHICLE IS EQUIPPED WITH THE OPTIONAL FRONT BUCKET SEATS AND CENTER CONSOLE, YOU
WILL NEED TO TRIM YOUR LINER TO ACHIEVE THE PROPER FIT ALONG THE BACK EDGE OF THE CONSOLE.
TO ADJUST FIT, SIMPLY TRIM AWAY THE MATERIAL ON THE CENTER HUMP PORTION OF THE LINER THAT
MATES UP TO THE CENTER CONSOLE (SEE DARKENED AREA IN DRAWING ABOVE). A TRIM GROOVE IS
MOLDED INTO THE LINER TO GUIDE TRIMMING. A UTILITY KNIFE OR HEAVY SHEARS WORK WELL FOR
TRIMMING. PHOTOS OF THE TRIMMED PART ARE SHOWN ON THE BACK OF THIS PAGE.
LEFT OR
DRIVER’S
SIDE
RIGHT OR
PASSENGER’S
SIDE
NOTICE: RIGHT LINER
OVERLAPS LEFT LINER
FRONT OF VEHICLE

6141 front and back-1.doc
03/07/06
PHOTOS OF PART #6141 TRIMMED FOR THE CHEVROLET TAHOE/GMC
YUKON/CADILLAC ESCALDE