HUSKY LINERS 6650 Manual

6650 Front_Back.doc
Rev: 2
12/26/01
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your
factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new floor
liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest
way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409®or Glass Plus®work well. Use of
Armor All®, Son-of-a-Gun®or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR NISSAN
XTERRA SECOND SEAT FLOOR LINER
DUE TO DIFFERENCES IN AVAILABLE CONSOLE CONFIGURATIONS, 2000/2001 XTERRA OWNERS MAY
NEED TO TRIM THEIR LINER AS SHOWN ABOVE. THE TRIMMING NECESSARY IS EASILY DONE BY
FOLLOWING THE SCRIBED LINE MOLDED INTO THE PART. A UTILITY KNIFE OR SCISSORS WORK WELL
FOR TRIMMING. PHOTOS OF TRIMMED AND UNTRIMMED PARTS ARE INCLUDED ON BACK.
LEFT OR
DRIVER’S SIDE RIGHT OR
PASSENGER’S SIDE
FRONT OF VEHICLE
NOTICE: LEFT MAT
OVERLAPS RIGHT MAT

6650 Front_Back.doc
Rev: 2
12/26/01
TRIMMING INSTRUCTION PHOTOS OF PART #6650
PART #6650 SHOWN UNTRIMMED. FITS 2002 MODEL
XTERRA AND FRONTIER CREW CABS (SHOWN IN INSET).
PART #6650 SHOWN TRIMMED TO FIT 2000 AND 2001
MODELS WITH LONGER CONSOLES. (SHOWN IN INSET).