6102_Installation Instruction Front_Back.doc
04/14/09
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
!
CARE AND USE INSTRUCTIONS
!
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your
factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new floor
liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest
way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409®or Glass Plus®work well. Use of
Armor All®, Son-of-a-Gun®or similar items is discouraged as these products make the liner slick.
!
INSTALLATION(INSTRUCTIONS(FOR(YOUR(BUICK(ENCLAVE/GMC(ACADIA/(CHEVROLET(
TRAVERSE/SATURN(OUTLOOK(2ND(SEAT(FLOOR(LINER(FOR(VEHICLES(WITH(2ND(ROW(
BUCKET(SEATING(WITH(OR(WITHOUT(A(FACTORY(CONSOLE(
YOUR VEHICLE IS EQUIPPED WITH 2ND ROW BUCKET SEATS THAT
CAN BE ADJUSTED TO MULTIPLE POSITIONS. YOUR HUSKY FLOOR
LINER IS DESIGNED TO ACCOMMODATE THESE POSITIONS. WITH
YOUR SECOND ROW SEATS POSITIONED FOR MAXIMUM 2ND ROW
PASSENGER LEG ROOM, YOUR LINER WILL FIT AS BOXED. IF YOU
WISH TO REPOSITION YOUR 2ND ROW SEATS FOR MAXIMUM 3RD SEAT
PASSENGER LEG ROOM, TRIM AWAY THE TREAD PLATED MATERIAL
FROM THE TWO RAISED AREAS LOCATED ALONG THE BACK WALL OF
YOUR LINER (SEE AREAS LABELED “1” ABOVE). THIS WILL ALLOW THE
2ND ROW SEATS TO MOVE FORWARD. IF YOU WANT TO STOW THE 2ND ROW
SEATS FOR MAXIMUM CARGO STORAGE, YOU CAN SIMPLY REMOVE THE
LINER FROM THE VEHICLE OR TRIM AWAY AREA “2” AS SHOWN ABOVE. TO TRIM
THIS AREA, USE THE STEP IN THE LINER AS YOUR TRIMMING GUIDE. LASTLY, YOUR
VEHICLE MAY BE EQUIPPED WITH A 2ND ROW CONSOLE. YOUR LINER WILL
ACCOMMODATE THIS CONSOLE. SIMPLY TRIM THE MATERIAL FROM AREA “3” SHOWN ABOVE. A MOLDED IN
GROOVE IS PROVIDED TO GUIDE TRIMMING. A UTILITY KNIFE WORKS WELL FOR TRIMMING. PHOTOS DETAILING
TRIMMING ARE INCLUDED ON THE BACK OF THIS PAGE.
