ICP DAS USA MDC-700 Series User manual

Technical support: [email protected]
MDC-700 Series
Quick Start
V1.1, March 2018




Technical Support
M
h

DC-700 User Manual
ttp://ftp.icpdas.com/pub/cd/8000cd/napdos/modbus/mdc700/document/
What’s in the Box?
The package includes the following items:



RS-232 Cable
(CA-0910)
Screw Driver
(1C016) 2.4 mm


MDC-700 ModuleDIN-Rail Mounting Kit
(Clip x 1, Screw x 4)
P1

Technical support: [email protected]
1Connecting to PC, Network and Power
The module is equipped with a standard Ethernet port (RJ-45) for
connecting to an Ethernet Hub/Switch and PC. Moreover, you can
also connect the PC directly with an Ethernet cable.

Powersupply
(+10~+30VDC)
Hub/Switch










2Assigning an IP address to MDC-700
The MDC-700 is an Ethernet device, which comes with a default
IP address of 192.168.255.1. You need first assign a valid IP
address of your network to the MDC-700 for accessing the module
and using the built-in web-based interface.
STEP 1: Power on the computer and the MDC-700.
STEP 2: Set the IP configuration on your computer.
If the MDC-700 is new, with the default IP address of
192.168.255.1, you must chose an IP address for the
computer in the range of 192.168.255.2 – 192.168.255.253
that is not already in use.
P2

Technical support: [email protected]
NOTE: Details on how to change the IP address on your
computer depend upon the type architecture and operating
system you are using. Use the computer Help and Support
functionality to search for “IP Addressing”.

STEP 3: Open a web browser and go to the website at
http://192.168.255.1, where 192.168.255.1 is the IP address
in your MDC module.
STEP 4: Confirm that the connection is successful on the page.
The connection to the MDC-700 is established.
The connection to the MDC-700 is not established.
STEP 5: Choose a valid IP address of the network for your MDC-700
Scroll down to ‘Ethernet Configuration’ section, input the
IP/Subnet mask and Gateway addresses and click on the
“Apply” button. Make sure that the IP address you pick is not
currently in use by another device on the network.
P3

Technical support: [email protected]
NOTE: The MDC-700 can be reset to factory defaults by
shorting the RESET pin to GND pin over 3 seconds. The LED
display will show “RESET” as below and the IP address set
previously will be removed.


STEP 6: Restore the IP address for your computer.
3Go to the Web Site
Go to the web interface at http://xxx.xxx.xxx.xxx, where
xxx.xxx.xxx.xxx is the IP address for your MDC-700.

Module Name
Connection Status










P4