ICP DAS USA WinPAC-5000 User manual

Copyright © 2012 ICP DAS Co., Ltd. All Rights Reserved. E-mail: [e-mail]
-1
WinPAC-5000 Quick Start Guide
Version 1.0.2, August 2012
Congratulations on purchasing Win PAC - the most popular automation solution for
remote monitoring and control application. This Quick Start Guide will provide
information needed to get started with WinPAC. Please also consult the User Manual
for detailed information on the setup and use of Win PAC.
In addition to this guide, the package includes the following items:
Win PAC Module
2 GB microSD card
Software Utility CD Screw Driver
(WP-5141/WP-5141-OD)
(1C016)
2.4 mm
●WinPAC 5000 User Manual
CD:\napdos\wp-5000_ce50\Document\
http://ftp.icpdas.com/pub/cd/winpac/napdos/wp-5000_ce50/document/
●WinPAC 5000 Website
http://www.icpdas.com/products/PAC/winpac/wp-5000_selection_guide.htm
•WinPAC-5000 Quick Start Guide

Copyright © 2012 ICP DAS Co., Ltd. All Rights Reserved. E-mail: [e-mail]
-2
WinPAC-5000 Quick Start Guide
1
--------------------------------------------------------------------------------
Configuring the boot mode
Before starting any installation,
be sure that the switch is placed
in the “0” position.
2
--------------------------------------------------------------------------------
Connecting to PC, Monitor and Power Supply
i. Connect the mouse or keyboard to the USB port.
ii. Connect the microphone and earphone to the microphone-in and
earphone-out (for WP-5141-OD only).
iii. Connect PC to the Ethernet port through a hub.
iv. Connect the power supply (10 ~ 30 VDC) to PWR and GND terminals.
v. Connect the monitor to the VGAport.

Copyright © 2012 ICP DAS Co., Ltd. All Rights Reserved. E-mail: [e-mail]
-3
WinPAC-5000 Quick Start Guide
3
--------------------------------------------------------------------------------
Changing the User Interface Language
The WinPAC Utility is a toolkit used to quickly control and manage the
WinPAC.
Step 1: Run the WinPAC Utility located on desktop
Step 2: Configure IP(DHCP), FTP Server,
Auto Execution…, etc
Step 3: Save and Reboot the
WinPAC

Copyright © 2012 ICP DAS Co., Ltd. All Rights Reserved. E-mail: [e-mail]
-4
WinPAC-5000 Quick Start Guide
4
--------------------------------------------------------------------------------
Inserting and Wiring the I/O Modules
The WinPAC expansion only supports XW-board series modules.
For more information about the XW-board expansion module, please refer to
http://www.icpdas.com/products/PAC/up-5000/XW-board_Selection_Guide.h
tm
After you have finished configuring your module(s), you may start to develop
your own applications. For detailed instructions and more applications, please
refer to WinPAC-5000 User Manual.