Idmed WiTOF User manual

MODES
TOF and Auto-TOF
Depending on the chosen stimulation, the results will be displayed in different
forms: T4/T1 ratio (%), number of responses (x/4 or x/10), bar graph.
ATP mode (Automated TOF/PTC)
PTC
Always read the insruction manual before use.
WiTOF and IDMED are registered trademarks owned by IDMED S.A.S. @IdmedNews •
3 rue John Maynard Keynes
13013 Marseille FRANCE
Tel.: [phone] •Email: [email protected]
www.idmed.fr
Automated measurement of light, medium and deep block level of the
patient by appropriately alternating TOF or PTC stimulations.
GRAPHIC INTERFACE
1
QUICK START
Graphical representation
Access the graph by pressing
Setting up high and low alerts
Access the alert conguration by pressing
23

SET UP
2
1
3Remove the sensor from its charging holder
• Red side of the case (proximal electrode) = near the heart
•Black side of the case (distal electrode) = away from the heart
•Check the patient’s impedance level on the station or
directly on the wireless sensor (green flash)
Position the hand splint
Position the splint at the last phalanx of the thumb
closely following the U-shape of the hand.
Check the sensor pairing
Ensure that the patient’s skin is clean and dry
4
5
Connect the power supply and press the ON/OFF button on
the back of the station.
Prepare the patient’s skin before placing the electrodes
Position the case and the electrodes on the ulnar nerve
Clip the electrodes onto the case before positioning the sensor
on the patient
6
Check the information displayed
7
Start a measurement
8
Sensor signal strength
Sensor battery charge level
Impedance level (green = optimal)
On the main screen, select the desired mode (ATP, TOF or PTC) or select a se-
condary mode in indirect access (DBS, TET ou ST).
Once in the selected the mode, touch and hold (2 sec) the corresponding
button to start a stimulation.