IFM Electronic efector200 OGP3 Series User manual

Operating instructions
Retro-reflective sensor
OGP3xx
UK
UK
704459 / 01 01 / 2009

2
1 Preliminary note
1.1 Symbols used
►Instruction
> Reaction, result
→Cross-reference
Important note
Non-compliance can result in malfunctions or interference.
2 Functions and features
In conjunction with a prismatic reflector or reflective tape the retro-reflective
sensor detects objects and materials without contact and indicates their presence
by a switching signal.
Range: (→type label).
3 Installation
1
LED1:
Fit the prismatic reflector or the reflective tape behind the object to be detected.►
Align the retro-reflective sensor to it and secure it to a bracket.►
Maximum range only with accurate alignment.

3
UK
4 Electrical connection
The unit must be connected by a qualified electrician.
The national and international regulations for the installation of►
electrical equipment must be adhered to.
Ensure voltage supply to EN 50178.►
Disconnect power.►
Connect the unit as follows:►
Connector
L+
L
1
4
3
pin 1 = L+
(pin 2 = not connected)
pin 3 = L-
pin 4 = load
Cable
BN
BK
BU
L+
L
BN = L+
BU = L-
BK = load
Core colours: BN = brown, BU = blue, BK = black
5 Operation
Check whether the unit operates correctly.►
Dark-on switching units (OGP-DPKG): the output is switched / the yellow LED•
is lit when an object is detected.
Light-on switching units (OGP-HPKG): the output is switched / the yellow LED•
is lit when no object is detected.
9 Maintenance, repair and disposal
Keep the front lens of the sensor free from soiling.►
For cleaning do not use any solvents or cleaning agents which could damage►
the plastic material.
Technical data and further information at
www.ifm.com →Select your country →Data sheet direct: