Indiana Furniture One 10 Block: Standard Top Conference Table User manual

Indiana Furniture 1
One 10 Block: Standard Top Conference Table Assembly Instructions 144” to 192” Lengths
Parts List:
Qty (2) Tops
Qty (2) Trough Assembly
Qty (4) Jointer Bolts
Qty (2) Jointer Plates
Short L-Brackets
Long L-Brackets
Hardware Included
•Bag of #10 x 3/4” Pan Head Screws
•Bag of ¼”-20 x 2-3/8” Bolt and ¼”-20 Nuts
•(18) Cover Caps
Tools Required
•(2) People
•Drill with phillips screw bit
•5/32” Allen Wrench
•5mm Allen Wrench
•10mm Wrench
•Level
Qty (2) Bases
Qty (1) Mid Leg

Indiana Furniture 2
Step 1: Remove the accent cover off of the bases by removing the thumb screws and pulling it off.Then bolt together (1) Base and (1) Mid Leg to (1)Trough assembly using the
¼”-20 x 2-3/8” Bolt and ¼”-20 Nuts. Next, Bolt the remaining Trough Assembly to the remaining Base Next screw on the Short L-Brackets and the Long L-Brackets using the #10
x3/4” Pan Head Screws spacing evenly. If the table is 48” wide, using the provided Cover Caps, cover the outside holes on the base.
Base With Accent Cover
Base With Accent Cover Removed
Bolt Trough Assembly together in (4) places
Bolt Trough Assembly together in remaining (4) places
Attach L-Brackets
Place Cover Caps here
on 48” wide tables

Indiana Furniture 3
Step 2: While keeping the outside and top surfaces flush, conenct the remaining top using the 10mm wrench and the provided Jointer Bolts. Be sure to center the Tops to the width
and the length of the trough assembly. Now, fasten the tops to the L-Brackets with the #10 x 3/4” Pan Head Screws. Next fasten the Jointer Plates to the Tops using #10 x 3/4”
Pan Head Screws.
Jointer Plate
Place Jointer Bolts in 1
st
then Fasten the Jointer Plates
Center Top with the Width of the Trough Assembly

Indiana Furniture 4
Step 3: Next, level the table using the 5mm Allen wrench.
Step 4: Push on Base Accent Panels and insert Thumb Screw from Step 1
Levelers Are Here
Levelers Are Here
Push Accent Panels On