Indiana Furniture One 10 Block 4 Piece Conference Table User manual

Indiana Furniture 1
One 10 Block: 4 Piece Conference Table Assembly Instructions 96” to 120” Lengths
Parts List:
Qty (2) Short Tops
Qty (2) Long Tops
Qty (1) Trough Assembly
Qty (8) Jointer Bolts
Qty (4) Jointer Plates
Short L-Brackets
Long L-Brackets
Hardware Included
•Bag of #10 x 3/4 ” Pan Head Screws
•Bag of ¼”-20 x 2-3/8” Bolt and ¼”-20 Nuts
•(12) Cover Caps (Optional)
Tools Required
•(2) People
•Drill with phillips screw bit
•10mm Wrench
•5/32” Allen Wrench
•5mm Allen Wrench
•Level
Qty (2) Bases
Qty (2) Jointer Plates

Indiana Furniture 2
Step 1: Remove the accent cover off of the bases by removing the thumb screw and pulling it off.Then bolt together the (2) Bases to the Trough assembly using the ¼”-20 x
2-3/8” Bolt and ¼”-20 Nuts. Next screw on the Short L-Brackets and the Long L-Brackets using the #10 x 3/4” Pan Head Screws evenly spaced. If the table is 48” wide, using the
provided Cover Caps, cover the outside holes on the base.
Base With Accent Cover
Base With Accent Cover Removed
Bolt Trough Assembly together in (4) places
Screw Short and Long L-Brackets on the
Trough Assembly
Place Cover Caps here
on 48” wide tables

Indiana Furniture 3
Step 2: Attatch (1) U-Jointer Plate to the bottom of (1) Short Top. Place one Short Top on the end of the Trough Assembly and fasten it to the L-Brackets using #6 x ½” Pan
Head Screws. Center the Top from left to right and align the Top flush with the outside of the base.
Make Top Flush with the outside of the base as shown.
Center Top with the Trough Assembly
Attach Jointer Plate

Indiana Furniture 4
Step 3: While keeping the outside and top surfaces flush, conenct the remaining tops using the 10mm wrench and the provided Jointer Bolts. Now, fasten the tops to the L-
Brackets with the #10 x 3/4” Pan Head Screws. Next fasten the Jointer Plates to the Tops using #10 x 3/4” Pan Head Screws.
.
Place Jointer Bolts in 1st then Fasten the Jointer Plates
Jointer Plate

Indiana Furniture 5
Step 4: Level the table using the 5mm Allen Wrench
Step 5: Push on the Base Accent Panels and insert thumb screws from Step 1
Levelers Are Here
Levelers Are Here
Push Accent Panels On