Indiana Furniture One 10 User manual

Indiana Furniture 1
One 10 Block: 5 Piece Conference Table Assembly Instructions 96” to 120” Lengths
Parts List:
Qty (2) Short Tops
Qty (2) Long Tops
Qty (1) Trough Assembly
Qty (1) Accent Cover
Qty (8) Jointer Bolts
Qty (4) Jointer Plates
Short L-Brackets
Long L-Brackets
Hardware Included
•Bag of #10 x 3/4 ” Pan Head Screws
•Bag of ¼”-20 x 2-3/8” Bolt and ¼”-20 Nuts
•(1) 29mm Silver Polycom Grommet (Optional)
•(12) Cover Caps (Optional)
Tools Required
•(2) People
•Drill with phillips screw bit
•5/32” Allen Wrench
•5mm Allen Wrench
•10mm Wrench
•Level
•1” Hole Saw Bit for Polycom Grommet (Optional)
Qty (2) Bases

Indiana Furniture 2
Step 1: Remove the accent cover off of the bases by removing the thumb screws and pulling it off.Then bolt together the (2) Bases to the Trough assembly using the ¼”-20 x
2-3/8” Bolt and ¼”-20 Nuts. Next screw on the Short L-Brackets and the Long L-Brackets using the #10 x 3/4” Pan Head Screws evenly spaced. If the table is 48” wide, using the
provided Cover Caps, cover the outside holes on the base.
Base With Accent Cover
Base With Accent Cover Removed
Bolt Trough Assembly together in (4) places
Screw Short and Long L-Brackets on the
Trough Assembly
Place Cover Caps here
on 48” wide tables

Indiana Furniture 3
Step 2: Place one short end on the end of the Trough Assembly and fasten it to the L-Brackets using #10 x 3/4” Pan Head Screws. Center the Top from left to right and align
the Top flush with the outside of the base.
Make Top Flush with the outside of the base as shown.
Center Top with the Trough Assembly

Indiana Furniture 4
Step 3:While keeping the outside and top surfaces flush, conenct the remaining tops using the 10mm wrench and the provided Jointer Bolts. Now, fasten the tops to the L-
Brackets with the #10 x 3/4” Pan Head Screws. Next fasten the Jointer Plates to the Tops using #10 x 3/4” Pan Head Screws.
Place Jointer Bolts in 1st then Fasten the Jointer Plates
Jointer Plate

Indiana Furniture 5
Step 4: Level the table using the 5mm Allen Wrench
Step 5: Place the Accent in the table, adjust the height of the Accent Cover by using the adjusable levlers on the bottom of the Accent Cover
Levelers Are Here
Levelers Are Here

Indiana Furniture 6
Step 6: Push on the Base Accent Panels and insert thumb screws from Step 1
Optional Step 10: Using a 1” Hole Saw Bit, drill a hole in the Accent Cover for the Optional Silver Polycom Grommet.
Bore Hole for Silver Polycom Grommet (Optional)