Indiana Furniture Tri-One Training Table C-Leg Flip User manual

1
Tri-One Training Table
C-Leg Flip
Parts List:
Qty (1) Work Surface
Hardware Included
(14) #12 x 1” Pan Head Wood Screws
(16) ¼”-20 x ¾” Flat Head Cap Screw
Tools Required
Drill with phillips screw bit
5"
32 Allen Wrench
½” Wrench
Qty (1) Post & Trough
Assembly
Qty (1) Pair of Feet
Qty (4) Castors
Assembly InstructionAssembly InstructionAssembly InstructionAssembly Instruction
Qty (1) Post & Trough

2
Step 1: Activate the flip mechanism by rotating the lever bar to rotate the top plates.
Step2 : Next, Bolt the top plates on the legs using the (8) ¼”-20 x ¾” Flat Head Cap Screws and the 5/32” Allen Wrench
Install Flat Head Cap Screws, (4) Per Leg
Tri-One Training Table
C-Leg Flip
Assembly InstructionAssembly InstructionAssembly InstructionAssembly Instruction
Tri-One Training Table
C-Leg Flip
Assembly InstructionAssembly InstructionAssembly InstructionAssembly Instruction
Tri-One Training Table
C-Leg Flip
Assembly InstructionAssembly InstructionAssembly InstructionAssembly Instruction

3
Step3 :Tighten up the 8 Screws in the latch plate going into the work surface
Step 4 : Using the provided #12 x 1” Pan Head Screws, install the remaining 14 screws in the latch plate. Then attach the feet to the leg columns using the ¼”-20x3/4” Flat head
Cap Screws
Tri-One Training Table
C-Leg Flip
Assembly InstructionAssembly InstructionAssembly InstructionAssembly Instruction

4
Step 5 : Using the ½” wrench screw on the castors. Important! : The Locking Castors are to be installed on the user side
Note: The table comes equipped with removable wire management covers as shown below. If it is necessary to route wires down the leg, you may rotate the wire
management cover so the notch is at the bottom in order for wires to exit.
Wire Covers pull off and
snap on.
Notch at Bottom for cord exit.
Locking Castor Here
Locking Castor Here
Tri-One Training Table
C-Leg Flip
Assembly InstructionAssembly InstructionAssembly InstructionAssembly Instruction