Inficon IRwin User manual

How to do a 1-point Calibration at 500ppm with your
IRwin Methane Leak Detector (Universal Mode)
(for a factory set unit)
QUICK START GUIDE
1 of 2 mimg66en1-01 (1906)
2
Make sure your IRwin is set with the right calibration
settings (see the How to set your IRwin for one point
calibration 500ppm quick start guide)
Use to navigate to Calibration and press
3
4
5
Press followed by
If prompted, press and enter the Intermediate
password code. If not prompted, go ahead to next
step
1
Make sure your IRwin is set in Universal Mode (see
the How to set your IRwin for Universal Mode quick
start guide)

www.inficon.com [email protected]
Due to our continuing program of product improvements, specifications are subject to change without notice.
All trademarks are the property of their respective owners.
©2019 INFICON mimg66en1-01 (1906)
How to do a 1-point Calibration at 500ppm with
your IRwin Methane Leak Detector
7
Expose the instrument to air and press
9
8
Expose the instrument to gas, 500ppm CH4, and press
6
Press to get to the drop-down menu. Use to
navigate to Universal (low range) (500ppm CH4).
Press
When the calibratiation is done, press followed by
Then press followed by