Inside Weather JORN CONSOLE User manual

JORN CONSOLE

Gather Your Eggs...
2x Mounting Screws Ratchet Long Hex Bit
Left Leg
Back
Shelves (Large or Small)
Top
Right Leg
Note: Please retain all boxes until you are certain that your product isn’t damaged and that you
do not wish to return it. Disposal of boxes may prevent/delay our ability to resolve your request.

Step 1: Attach Shelves to Back Panel
Grab your shelves (Large or
small depending on your
custom order).
Align connectors on the shelf
with the holes on the back
panel, attach.
Fasten using provided
ratchet and long hex bit.
Repeat on other side.
Start by placing the back
panel with the keyhole side
down on a soft surface so that
you don’t damage your peice.
Note: When fitting the peices together, make sure the connecting screws are
retracted inside their housing. Having the screw out could damage your surfaces.

Step 2: Attach First Leg
Grab the Right Leg and align the hole on the
interior of the leg with the connector on the
shelf and tighten with ratchet.
Step 3: Attach Second Leg
Repeat Step 3
for the other leg.

Step 4: Attach Console Top
Align connectors on the Console Top with the
holes on the back panel and legs, attach.
Detail View

Step 5A: Wall Mount Prep: Measure
Place the console against the wall
Make a small mark along the top edge and
the side edges. Use the marks to measure
2 inches down from the top and 6 inches
in from the sides to determine where to put
the screws into the wall.
Next you want to secure your console to wall. It is not advised
to use this product without safely anchoring to the wall.
Step 5B: Wall Mount Prep: Drill
Use the provided screws. Screw into the
anchors taking care not to overdrill and
strip the anchor.

Step 6: Mount to the Wall
Wall Rear of Unit Keyhole Opening Side View
With the back of your console facing the wall, Lift the unit slightly and place the head
of the drywall screws into the bottom opening of the keyholes on the back. Press the
console against the wall and slide it down onto the screw until the feet touch the floor.
DONE!
Your unit is now securely attached
to the wall and ready to use.