Inside Weather NOLA DINING CHAIR Series User manual

NOLA DINING CHAIR COLLECTION
These instructions are for the Nola Armchair and the Nola Side Chair

Gather Your Eggs...
You should have:
LEGS
2x Pucks
4x Metal Washers
1x Hex Key
CHAIR BODY
PLEASE NOTE: These assembly instructions are the same across all base
styles for the Nola chair. So even though you see one style pictured here,
the same instructions will apply to the base you’re holding in your hands!
Note: Please retain all boxes until you are certain that your product isn’t damaged and that you
do not wish to return it. Disposal of boxes may prevent/delay our ability to resolve your request.
The parts shown here are all the available options. The parts you have will depend on your custom order.
2x Puck Connectors
2x Short Flat-Head Screws
4x Short Button-Head Screws

Step 1: Attach the Pucks
Place a puck with the slot facing upward. Insert a flat head
screw and use the hex key to fasten the pucks, but don’t tighten
them all the way. The pucks should be loose enough to swivel.
By now your chair should look something like this.
Next up are the legs.
Flat-Head Screw
Puck

Flip the chair base onto the seat so
that the back leg aligns over the rear
mounting holes and the front leg
mounting holes align over the slot of
the pucks.
Note: chair bases have a front and
a back, so if they don’t align at first,
the legs are probably sideways or
backwards. Rotate the base 90° or 180°
and try again.
Next, take your button-head screw and
insert through the back leg mounting
holes and lightly tighten so that your
legs are in position.
With the back secure, pivot the front
pucks so that the mounting holes align
with the slot on the puck. Once you
have the front pucks in position, use
your hex key to fully tighten the flat
head screw in the puck.
Note: Ensure the tab of the mounting
hole is not parallel with the slot as this
can cause the hardware to slip.
NO YES
Step 2: Attach the Base

Step 2: Attach the Base
DONE!
Grab your puck connectors and slide 1
into each puck. If your mounting holes
are closer to the center of the puck, insert
the short side first. If they are closer to the
edge, insert the long side first.
• Move the connector into position so that the threads align with the
leg mounting hole on the chair base.
• Insert a button-head screw and lightly tighten.
• Repeat on other side
• Once all screws are inserted, tighten both of the
front screws.
• Move to the back legs and fully tighten
• Flip the chair onto its legs.