Inside Weather HAVEN BED User manual

HAVEN BED

Gather Your Eggs...
Note: Please retain all boxes until you are certain that your product isn’t damaged and that you
do not wish to return it. Disposal of boxes may prevent/delay our ability to resolve your request.
Back Panel
Legs
Mega-Slats
Slats
Side Panel Supports
Front Panel
Bracket Bolt Ratchet6mm x 25 Hex Bit

Step 1: Prepare Center Supports
Assemble on a soft surface to
protect from scratches.
Lay down the front panel and
rear panel.
Lay down the center supports
between the front and rear panel.

Insert a center support into the
alcove in the back panel.
Insert the bracket bolts. Use
the ratchet and hex bit to
tighten all four brackets.
Step 2: Attach Center Supports

Step 3: Attach Side Panels
Position the side panels next
to the frame with the brackets
facing up.
Ley the mega- slats down on
the frame, aligned with the
brackets on the side panels.
Insert one end of the mega-slat bracket
forks into the corresponding slots in the
side panel bracket. Insert the other side
into the corresponding bracket. Then
insert the bracket bolts and tighten.
Repeat for the remaining mega-slat.

Step 4: Attach Legs
Position a leg near each corner
of the bed frame.
Lift the side panel to align
with the corresponding
bracket on the leg.
Slide the bracket forks on
one side of the leg into the
bracket in the side panel.
Line up the adjacent
bracket and insert.
Repeat for each leg.
Add bracket bolts and
tighten.

Step 5: Insert Slats
Insert all the slats by first sliding
them into their alcoves, and
then laying flat on the supports.
Repeat for all slats.
Step 6: Add Your Bedding
DONE!
DONE!
Add your mattress and
bedding, and relax!

Fabric Care Instructions
Cleaning Codes
Machine Washable
Spot Cleaning
SOLVENT OR WATER CLEANABLE (S/W)
WATER CLEANABLE (W)
SOLVENT CLEANABLE (S)
SPOT CLEAN ONLY (SC)
Spot clean with upholstery shampoo, foam from a mild detergent, or a mild dry cleaning solvent.
Spot clean fabric with a water-based shampoo or foam upholstery cleaner. Avoid over-wetting the stain.
Must be cleaned with solvents (dry clean only). Spot treat stains with a water-free solvent or
dry-cleaning product.
Cleaning depends on the nature of the stain. For oil-based spots, do not apply water and use dry
cloth. Recommended use of leather-specific solvents & cleaners.
Each fabric type has a specific cleaning code which can be found on the Free Swatch Page.
Many of our fabrics are machine washable. If a fabric is machine washable, it’ll be noted in the
cleaning instructions on the Free Swatch page. It must be Machine Wash - Cold. Use Cold Water
and a mild detergent on a low/gentle cycle. Hang dry all covers. Please note that every machine
wash adds wear to the fabric so it’s recommended to opt for spot cleaning prior to machine
washing whenever possible.
We recommend spot cleaning with either an upholstery shampoo, foam from a mild detergent, or
a mild cleaning solvent. Always hang to dry. When spills happen, blot immediately to remove the
spilled material. Clean spots or stains from the outside to the middle of the affected area (this prevents
circling). To prevent overall soiling, frequent vacuuming to remove dust and grime is recommended.