Inside Weather SARNO CHAIR User manual

SARNO CHAIR

Gather Your Eggs...
10x Button Head Screw
2x Short Wood Screw
8x Pocket Hole Screw
Legs
SeatSide BracesFront Brace
Back Brace
Seat Back
Note: Please retain all boxes until you are certain that your product isn’t damaged and that you
do not wish to return it. Disposal of boxes may prevent/delay our ability to resolve your request.
Allen Key

Step 1: Assemble the Legs
Distinguish Leg A and Leg B from their notches.
Leg B slots into Leg A
(Leg A, notch faces up. Leg B, notch faces down).
Facing the front of the chair, make sure the back
of Leg A is on the left and Leg B is on the right.
Assembled legs will criss-cross
each other
NOTE: To ensure the legs are oriented correctly, check that
the hole openings for the back brace are higher than the
hole openings for the side braces.
Leg Side A Leg Side B
Leg Notches
Correct Incorrect

Step 2: Place the Seat
Place the Seat down on the
criss-crossed legs.
Push the seat all the way back into the
notches in the rear of the legs.
Hand tighten the button head screws through the
holes from the bottom. Do not fully tighten yet.

Step 3: Attach the Back
Align the holes in the Seat
Back with the tops of the legs
and cap it on.
Use the short wood screws and tighten into the seat back until the
screw is flush with the surface.

Step 4: Add the Front and Rear Leg Braces
Align the Front Leg Brace with the
corresponding holes in the legs.
Repeat with the rear brace.
Step 5: Add the Side Leg Braces
Now fit the side braces in place using
the same steps as previously.
Step 6: Tighten the Seat Screws
Using the provided allen key,
go back and tighten the scews
on the bottom of the frame.

Step 7: Add the Wood Screws
Step 8: Enjoy
DONE!
Gently screw the pocket hole screws
into the wood dowels.