Inside Weather ADA LOUNGE CHAIR User manual

ADA LOUNGE CHAIR

Gather Your Eggs...
Note: Please retain all boxes until you are certain that your product isn’t damaged and that you
do not wish to return it. Disposal of boxes may prevent/delay our ability to resolve your request.
Back Cushion (Optional)
Back Legs
Front Legs
Seat
Armrest
6x 55mm Bolt 4x Self Tapping Wood Screw
6x Washer Allen Key
Also Needed: Phillips Head Screwdriver (Not Included)

Step 1: Attach Legs
Step 2: Attach Armrests
Place the seat upside down
on a table. Use a soft surface
to protect from scratches.
Align the front and back legs
with the corresponding holes
in the seat bottom.
Attach with the 55mm bolts
and washers. Tighten to snug.
Set the wooden armrest face down.
Set the leg and seat assembly on
the armrest. (The “flat’’ side of the
armrest attaches to the legs). Position
the assembly so that the legs are
roughly centered on the armrest and
approximately 1-2 inches back from the
front of the arm.
Once you have the assembly centered
front and back and are satisfied with the
location, use a phillips head screwdriver
and the 4 self tapping wood screws to
attach the legs to the armrest.
Rear
Front

Step 3: Tighten
Step 4: Flip Chair Onto Legs
Go back and tighten all the
bolts and screws fully.
Flip the chair over onto its legs. Place the
back pillow.
DONE!