Inside Weather KOBE User manual

KOBE • LUNA • POLK DINING CHAIRS

Gather Your Eggs...
You should have:
LEGS
2x Thick Rubber Washers 2x Thin Rubber Washers
2x Puck Connectors
2x Short Flat-Head Screws
2x Short Button-Head Screws
2x Pucks
2x Long Button-Head Screws
4x Metal Washers
1x Hex Key
CHAIR BODY
Note: Please retain all boxes until you are certain that your product isn’t damaged and that you
do not wish to return it. Disposal of boxes may prevent/delay our ability to resolve your request.

Before You Start
Step 1: Place Washers and Attach Pucks
The easiest way to assemble the chair is to have
the seat lying flat. This can be arranged by
hanging the seat of the chair over the edge of an
elevated flat surface, such as a table, or even the
box in which the chair arrived!
Lay down a towel or blanket between the chair
and your surface of choice in order to avoid any
scratches or scuffs.
Heat your oven to 350°F and throw some nachos
in there so you have something to eat when
you’re done. Should be about 10 minutes.
• Place a thick rubber washer over each of the
2 mounting holes located towards the back
of the seat
• Place a skinny rubber washer over each of the
2 mounting holes located towards the front
of the seat.
• Place a puck on top of the front thin washers.
Make sure the slotted-side is facing up.
• Fasten both pucks using a flat-head screw. Do
not fully tighten until next step.
Back Washers Front Pucks
Long Button-Head Screw Short Flat-Head Screw
Metal Washer Puck
Thick Rubber Washer
Thin Rubber Washer

Step 2: Attach the Base
Flip the chair base onto the seat so
that the back leg mounting holes align
over the back washers and the front leg
mounting holes align over the slot of the
pucks.
Note: chair bases have a front and
a back, so if they don’t align at first,
the legs are probably sideways or
backwards. Rotate the base 90° or 180°
and try again.
Next, take your long button-head screw
with a metal washer and insert through
the back leg mounting holes and lightly
tighten so that your legs are in position.
With the back secure, pivot the front
pucks so that the mounting holes align
with the slot on the puck. Once you
have the front pucks in position, use
your hex key to fully tighten the flat
head screw in the puck.
Note: Ensure the tab of the mounting
hole is not parallel with the slot as this
can cause the hardware to slip. NO YES

Grab your puck connectors and slide 1
into each puck. If your mounting holes
are closer to the center of the puck, insert
the short side first. If they are closer to the
edge, insert the long side first.
Step 2: Attach the Base
• Move the connector into position so that the threads align with the
leg mounting hole on the chair base.
• Place a washer over the leg mounting hole and insert a button-head
screw and lightly tighten.
• Repeat on other side
• Once all screws are inserted, tighten both of the
front screws.
• Move to the back legs and fully tighten
• Flip the chair onto its legs.
DONE!