Ipc Ct 15 b User manual

This guide is intended for quick consultation only and does not replace the user and maintenance manual.

Before using the machine, read the user and maintenance manual contained in the machine’s packaging thoroughly and strictly follow all the

instructions.

PREPARATION & OPERATION

CT15 B Quick guide

PLDC01957

AUTO

ECO

CHEM

> 3”

REPLACING THE SQUEEGEE BLADES

ATTACHING/REMOVING THE BRUSH

• unscrew the nuts xing the blade retainers;

• remove the two blade retainers;

• remove the blade;

• put the same blade back, reversing the edge in contact with the oor until all four edges are worn, or replace with a new one;

• put the two blade retainers back on the squeegee and screw up the nuts again;

Attaching the brush:

• rest the brush on the oor in front of the machine. Raise the front of the machine by levering on the handle, then lower it onto the brush, centring it with the brush cover. Action the drive lever repeatedly until the brush

engages..

Removing the brush:

• Raise the front of the machine by levering on the handle, then operate the brush lever repeatedly. After operating the lever a few times, the brush is released and falls to the ground.

DAILY MAINTENANCE

Clean the dirty

water tank.

Check the dirty water tank oat

is undamaged and clean and

moves freely on the pin.

Check that the

detergent outlet lter

is clean.

Check that the brush is clean.

Replace if necessary.

Check that the