John Lewis Chevron 820 88801 User manual

Chevron Sofa
820 88801
695 1749 740mm

15 mins
this Chevron Sofa.

When attaching the frames together, make sure all the holes are in position with the screws before tightening.

Chair 695 x 1749 x 740mm
1620 x 700 x 70mm
500 x 800mm
450 x 450mm
255 x 75 x 25mm
Seat Cushion
Side Cushion
Middle Leg
2
2
1
Back Cushion
820 88801
Chevron Sofa overall size: H69.5 W174.9 D74cm
Your Chevron Sofa
5
5

Screw M6 x 18mm
12 x 6 x 1mm
16 x 16 x 5mm
2
2
2
Washer
Screw Cap
Allen key M6

820 88801
Chevron Sofa
15
C
A
B
1 5
3
4
2
2

Chevron Sofa
820 88801

This product is made from Aluminium
and is suitable
for outdoor use.
Please make sure that all surfaces are protected from heat and liquids by mats and coasters.Wipe up any
spills immediately and make sure that a mat or pad is placed under any paper if writing.
To extend the product life and appearance it is recommended to store the furniture in a cool dry, well
ventilated place such as a garage or shed over winter or during periods of unseasonal weather.
Ensure that the furniture is clean and completely dry before putting in to storage. Do NOT enclose the
product in a plastic or other non-permeable material as this promotes rust. Cover it with a dust sheet
or furniture cover allowing the air to circulate around it.
We recommend that you clean your furniture at the beginning and end of the season.To clean the
furniture remove all dirt using mild soap and water. Never use abrasive chemicals or cleaning agents.
Rinse thoroughly and allow to dry. Bird droppings and tree sap should be cleaned off immediately.
If your furniture comes with cushions, when not in use it is recommended that they are stored in a clean
and dry environment. Wipe up any spills immediately and always refer to the care label which will either
be sewn to the back of the cushion or sewn inside if your cushion has a zip closure.
This furniture has been designed for domestic use only.
Furniture can be dangerous if incorrectly installed or assembled, it should be carried out by a competent
person.
No liability will be accepted for damage or injury caused by incorrectly installed or assembled furniture.
It is recommended that before moving heavy objects to a new location they are completely dis-assembled
to avoid personal injury or damage to the furniture. Please be careful to retain all fittings when doing this.
Never drag furniture when moving it, always lift it.
Periodically check all fixings to ensure none have come loose and re-tighten where necessary.
Please take care when handling or moving the furniture as careless handling may cause damage or injury.
Ensure that the furniture is always on a solid and level surface at all times.
With all articulated furniture, please exercise care when folding, unfolding and adjusting positions to avoid
any possibility of pinched or trapped fingers.
Important safety note:
Do NOT:
Use the chair as a ladder
Stand on the seat of the chair
Climb on the chair
Never tilt the chair and Ensure the chair is always placed firmly on a solid level surface.
Care and maintenance
Important safety information
Care guide
Your feedback is very important to us and we would love to hear
your comments on your new furniture. Please visit our website to
leave a review. Thank you.
Retain these instructions for future reference.