John Lewis Devon 820/81602 User manual

1
John Lewis
Devon Pod Chair
Stock number: 820/81602
Thank you for purchasing this pro uct. Please rea the instructions carefully before use to ensure safe
an satisfactory operation of this pro uct
Pre-assembly preparation
Please ensure instructions are rea in full before attempting to assemble this pro uct
Necessary Tools
Please check the pack contents before attempting to assemble this pro uct. A full checklist of
components is given in this leaflet. If any components are missing, please contact the retailer from whom
you bought this pro uct.
This pro uct is HEAVY, it shoul be assemble as near as possible to the point of use. TAKE CARE
HEN LIFTING to avoi personal injury an (or) amage to the pro uct.
This pro uct takes approximately 20 MINUTES to assemble with 2 PEOPLE.
The fittings pack contains SMALL ITEMS which shoul be KEPT A AY FROM YOUNG
CHILDREN.
Rea this leaflet in full before commencing assembly.

2
Fittings and parts checklist
A 1x Pillar 1 G 1x Carabiner
B 1x Pillar 2
H
2x Bolt (M10*70)
C 1x Base I 2x Spring Washer
D 1x Seating Po J 4x Flat Washer
E 1x Pin K 2x Nut (M10)
F 1x Chain L 2x Spanner

3
Step by step assembly instructions
Step One
Attach Pin (E) to Pillar 1 (A).
______________________________________________________________
Step Two
Attach Chain (F) to the Pin (E) Using the nut an bolt assembly which is pre-fitte to Chain (F)
____________________________________________________________________________
Step Three
Assemble the support frame by inserting Pillar 1 (A) in to Pillar 2 (B), an then Pillar 2 (B) into the
Base (C). Ensure all holes are aligne an then secure with Bolt (H), 2x Washer (J), Spring Washer (I)
an Nut (K) as shown below.

4
______________________________________________________________
Step Four
Attach Carabiner (G) to the Seating Po (D).
______________________________________________________________
Step Five
Clip the seating Po assemble in Step Four to Chain (F). Ensure the Carabiner (G) is fully close .
The Po Chair is now rea y to use.

5
Care and Maintenance
To clean the chair, simply be wipe own by han with a amp sponge an a weak solution of soap an water. Do
not use abbrasive cleaners as these will amage the synthetic wicker.
Safety Instructions
Never rag furniture when moving it, always lift it.
Perio ically check all fixings to ensure none have come loose an re-tighten where necessary.
Please take care when han ling or moving the furniture as careless han ling may cause amage or injury.
Furniture can be angerous if incorrectly installe . Assembly shoul be carrie out by a competent person. No
liability will be accepte for amage or injury cause by incorrectly insalle or assemble furniture.
It is recommen e that before moving heavy objects to a new location they are completely is-assemble to
avoi personal injury or amage to the furniture. Please be careful to retain all fittings when oing this.
Never tilt the chair. Ensure the chair is always place firmly on the groun .
Do not use this chair as a swing, climbing frame or a la er as this coul lea to the chair becoming unbalance
an overturning.
This chair is esigne for safe use by one person only.
PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
John Lewis Partnership 171 Victoria Street Lon on SW1E 5NN
www.johnlewis.com