IL4111
Thank you for purchasing this Didi table lamp. Please read the instructions carefully
before use to ensure safe and satisfactory operations of this product.
Please keep this instruction for future reference.
Warnings!
The supply cable runs through the inside of this product. Take care not to place
undue stress on the cable whilst unpacking to prevent the possibility of a poor
connection.
If you are in any doubt consult a person competent to give advice on the
assembly of electrical equipment.
If the external flexible cable of the lamp is damaged it shall be exclusively
replaced by the manufacturer or his service agent or a similar qualified person in
order to avoid a hazard.
To prevent electrocution switch off at the mains supply before assembling or
maintaining this fitting. Ensure the plug is not connected to any power supply and
read instructions before assembly.
Always be sure to use the correct type and wattage of bulbs as indicated on the
fitting. Never exceed the wattage stated.
When changing the bulb, always switch off at the mains and allow the old bulb to
cool down before handling. Dispose of used bulbs carefully.
Caution! The bulb and surrounding parts can become hot during use.
The fitting should be installed so the bulb is no closer than 30cm from the surface it is
illuminating =
For indoor use only.
Care instructions
We recommend cleaning with a soft dry cloth. Do not use abrasive materials as
these will damage the finish.
Replace bulbs from John Lewis or established brand of the same type and
compatibility.
Parts list
Step 1
Instructions for use
Carefully unpack the product from its packaging.
LED Bulb is pre-fitted to the product.
This product has a tilt angle range of approximately 10°.
Insert the wall plug into mains power outlet.
Bulb Replacement
Unplug from wall plug from the mains outlet and allow
the lamp to cool before replacing the bulb.
Remove the bulb using bulb suction fitting tool, turn
anticlockwise to remove bulb.
Insert a new bulb into the lamp holder. (see below)
Table lamp is now ready for use.
Supplied LED GU10 bulb information:
