Thank you for purchasing this
EMILIA TOUCH LAMP SET OF 2
read
the instructions carefully before use to ensure safe and
satisfactory
operation of this product.
Step 1
Carefully unpack the carton, making sure
all parts are present before
assembly.
Place lamp on a flat surface.
The fitting is class II.
This fitting should be fitted in accordance with IEE Regulations and the Building
Regulations. If in any doubt, or where required by law,
person who is registered with an electrical self-
certification
scheme. Further information is available online or from your Local Authority.
To prevent electric shock switch off at the mains supply before installing or
maintaining this fitting. Ensure other persons cannot restore the electricity supply
without your knowledge.
If you are in any doubt, please consult a qualified electrician.
If replacing an existing fitting, make a note of the connections.
Always use the correct type and wattage bulb. Never exceed the wattage
stated.When changing a bulb, always switch off at the mains and allow the old
bulb to cool down before handling. Dispose of used bulbs carefully.
The flexible cable of this product is
not replaceable. If damaged, the product shall
be disposed of
.
It is the installer’s responsibility to ensure that the fixings and
wall
plugs used are
suitable for the surface you are fixing your product on.
CAUTION! The bulb and surrounding parts can become hot during use.
Insert the plug into the power supply
and
touch on the base to light on..
(not included) to lamp holder
as indicated. The maximum power
indicated must not be exceeded.
Attach crystal chains
o the frame as shown
in the diagram.
3
on top of the table
lamp frame as indicated in the diagram.
Pay attention that the side with screw
downwards.
No. Picture Name Qty
L199XW14 CRYSTAL CHAIN X21
DIAMETER 93 STAINLESS
STEEL SHEET X1
DIAMETER 13XH23CM LAMP
BODY X1
