John Thomas TC-922 User manual

ITEM
NO.
:
TC
-
9
22
REVISED OCT 31, 2014
Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No.
: STORAGE CHEST 22 IN
: TC-922

ITEM
NO.
:
TC
-
9
22
REVISED OCT 31, 2014
Printed in Vietnam
- 2 -
BEFORE ASSEM
B
LY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
WARNING:
Long exposure to rubber or soft plastic may cause a chemical reaction and damage the finish of your
product. Protect the surface of the product with cloth if you are using any product with rubber feet or
base.
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM
NO.
:
TC
-
9
22
REVISED OCT 31, 2014
Printed in Vietnam
- 3 -
PART
LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO
Description
Q
ty
Sketch
NO
Description
Q
ty
Sketch
A Top panel 1 D Front
panel 1
B Back
panel 1
E Side panel 2
C
Support
bottom
panel
1 F Bottom
panel 1
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1 Bolt
(M6x30mm) 8
4 Hinge 1
2
Spring
washer
(Φ6.5x11mm)
8 5 screw
(M4x15mm) 14
3 Flat washer
(Φ6.5x13mm) 8
6 Allen key
(4x80mm) 1

ITEM
NO.
:
TC
-
9
22
REVISED OCT 31, 2014
Printed in Vietnam
- 4 -
STEP 1
Attach Back panel (B) to Side panels (E) with Bolts (1), washers (2) and (3) as shown below. Tighten
with Allen key (6).
STEP 2
Slide bottom panel (F) into groove of the unit as shown below.
Insert suppport bottom panel (C) into the unit all the way. Then attach Front panel (D) to the unit
with Bolts (1), and washers (2) and (3) as shown below. Tighten with Allen key (6).

ITEM
NO.
:
TC
-
9
22
REVISED OCT 31, 2014
Printed in Vietnam
- 5 -
Attach top (A) to the unit with screws (5), as shown below. Tighten with a screwdriver.
Attach hinge (4) to the unit with screws (5) as shown below.
STEP
3
STEP
4