JVA Wi-Fi Anywhere WA20M User manual

JVA Solar Wi-Fi Fence Monitor
Quick Start Guide
WA20M
PTE2701
The JVA Logo is a registered trademark of JVA Technologies
© JVA Technologies

Page 2
Introducon
The PTE2701 JVA Wi-Fi Fence Monitor provides an integrated Wireless
Cellular USB Dongle (Wingle) power supply with a solar baery charger
and management system.
This product provides a Wi-Fi network wherever a 3G/4G signal is avail-
able*. The Wi-Fi can then be used to connect an IP device or Internet of
Things (IoT) device to the Cloud (Internet).
The JVA Solar Wi-Fi Fence Monitor is paired with the Wingle at the fac-
tory, all you need to do is:
1. Register the SIM card
2. Add the Fence Monitor to the IP Energiser Controller app on your iOS
or Android device
This quick-start guide explains how to connect your PTE2701 to a fence
and turn it on.
*An external cellular antenna (included) may be connected to increase
recepon. An upgraded YAGI style antenna is available from sales@jva-
fence.com.au
Specicaons
Component Informaon
Solar Panel Nominal 12v Solar Panel
(maximum open circuit voltage - 22v DC)
Maxmium Power 20W
Baery Nominal 12.8v DC
Minimum Baery size 18Ah
A larger baery may be required if any addiontal
12v device is connected to the baery

Page 3 JVA WA20M
Component Informaon
Outputs(1) 12v DC SAE Connector
Used for powering the IP Monitor
Outputs (2) 12v DC Baery Connector
Alligator clips for baery connecon
SIM Full Size
Wi-Fi 2.4GHz b/g/n
Up to 10 connecons at a me
Network
(Huawei E8372)
3G 850/2100MHz
4GX 700MHz + 4G B1/3/7/21
Antenna Connector Female SMA
Ensure antenna is mounted away from sources of
interference such as AC or high voltage cables.
Troubleshoong
Fault Likely Cause Remedy
No lights are on Power is not connected
Power wires are re-
versed
Check power connec-
ons
Check baery polarity
Ba level ashing Baery disconnected
Bad baery
Check baery connec-
ons
Check baery voltage
USB_5V LED o USB device drawing
too much current
Unplug USB device,
check for damage/
seek manufacturer
advice

Page 4 © JVA Technologies www.jva-fence.com
Fault Likely Cause Remedy
Baery not charging Solar wiring backwards
Broken cables
Solar panel broken
Check that the Solar +
goes to the le-hand
screw terminal
Check that the baery
cables are not dam-
aged
Check solar panel for
physical damage (bro-
ken glass, bent frame
etc.)
Cannot connect to
Wi-Fi
Low signal from 3G/4G
Out of Wi-Fi range
(~10m)
SIM card not inserted
correctly
Check management
page of Wingle
Move closer to Wingle
Re-insert SIM card
If the unit is sll not working correctly, contact your nearest JVA distribu-
tor for technical support.
Troubleshoong the IP Monitor
Fault Liklely Cause Remedy
Status LED o Power failure Check connecons
and baery level
Status LED green Normal operaon,
connected to internet
and ready to operate
No acon necessary
1 Red ash IP Monitor is not con-
nected to Wi-Fi, this is
factory default mode
Congure the IP
Monitor to connect
to the Wingle’s Wi-Fi
network

Page 5 © JVA Technologies www.jva-fence.com JVA WA20M
Fault Liklely Cause Remedy
2 Red ashes IP Monitor has re-
ceived Wi-Fi congu-
raon and is aempt-
ing to connect to
Wi-Fi network
If persistent (more
than 2 minutes)
Factory default and
try to congure again
3 Red ashes IP Monitor is connect-
ed to Wi-Fi and is con-
nected to the internet
This should not dis-
play for more than 20
seconds, aer which
it will turn green. No
acon necessary
4 Red ashes Failed to connect to
Wi-Fi, the unit will try
again
If this persists, fac-
tory default and try
to congure again. If
more than 10m away
from Wingle, move
closer.
5 Red ashes IP Monitor has incor-
rect password
Default the IP monitor
and re-congure
If the unit is sll not working correctly, contact your nearest JVA distributor for
technical support.

Page 6 © JVA Technologies www.jva-fence.com
Before you start
Acvate the SIM card
Acvate your SIM card and test it in a mobile phone. The Wi-Fi network
allows a data-only connecon, the number of devices connected to the
module will determine how much data will be used.
As a guide, a single IP Energiser or IP Monitor will use less than 1MB per
day, so for connecng a single IP Energiser, an upper limit of 500MB per
year is an opon with a lot of headroom.
Overview
LED Indicators
D1 (Solar) Solid on when solar panel in sunlight
Blinking when solar panel in low power condions
O when no solar power detected
D6 (USB_5V) Solid on when USB Power is turned on
Ba Level Boom LED ashes if no baery is disconnected or bad
Shows baery level from boom to top: 25% to 100%

Page 7 © JVA Technologies www.jva-fence.com JVA WA20M
Congure IP energiser Controller App
Download the IP Energiser Controller applicaon (IPEC) from the app store or
google play.
Add a site to your IPEC app:
1. Press the menu hamburger at the top le
2. Press “Add Site”
3. Name the Site anything appropriate e.g. “North East 6km”
4. Fill in the Unit Serial Number with the serial number of the IP Monitor. This
can be found on the boom at the back of the IP Monitor.
5. Fill in the Unit Password with the same Serial Number used just before.
The default password set by factory is the serial number of the IP Monitor.
6. 6. Select the “Device Type” as “IP Monitor”
7. Set alarm thresholds for voltage and current accordingly. The IPEC app will
nofy you if the IP Monitor hits or exceeds these thresholds.
8. Press “OK”

Page 8 © JVA Technologies www.jva-fence.com
Connect IP Monitor
Opon 1 - Monitor the end of a fence
Turn o Energiser before starng
Green Terminal to Fence Ground (Earth)
Yellow Terminal to Fence Live
Red Terminal (nothing connected)
Advantages:
• End of Fence Voltage Monitoring
• Cut detecon
• Fence Load detecon
Limitaons:
• No Current monitoring
• No fence armed state control1
1. Relay funcon not available on IPM variant (PTE2606) - requires IPM-R

Page 9 © JVA Technologies www.jva-fence.com JVA WA20M
Opon 2 - Monitor from the start of the fence(s)
Turn o Energiser before starng
Green Terminal to Fence Ground (Earth)
Yellow Terminal to Fence Live
Red Terminal to Energiser Output (high voltage)
Advantages:
• Current Monitoring
• Voltage Monitoring
• Ability to control the fence armed state1
Limitaons:
• No cut detecon
1. Relay funcon not available on IPM variant (PTE2606) - requires IPM-R

Page 10 © JVA Technologies www.jva-fence.com
Baery Connecon and First Power On
Connect the baery to the PTE2701 by the included baery connecon
cables. Ensure that the posive is connected to the red connector, and
the negave to the black connector.
Once connected, the Ba Level indicator lights will show the approximate
voltage level of the baery.
If everything is connected, the IP Monitor will have a Green status light.
This will now be available and online in the IP Energiser Controller ap-
plicaon.

Page 11 © JVA Technologies www.jva-fence.com JVA WA20M
JVA Distributors
If you have quesons or need further assistance, please email us at sales@
jva-fence.com.au or call
Region Number
Australia 0731 030 582
South Africa 0861 782 349
World Wide [phone]
For more informaon on our complete range of electric fencing products
please see the JVA website at hps://www.jva-fence.com.au

Tel : [phone] Email : [email protected]om.au
www.jva-fence.com
The JVA Logo is a registered trademark of JVA Technologies
© JVA Technologies