JWA MORRIS 76372 User manual

2 ITEM CODE 70371
ASSEMBLY INSTRUCTION
Imported by JWA Furniture Pty Ltd, Brisbane ,Qld, Australia.
For any assistance with assembly or for missing parts please refer to your receipt
MORRIS 3 DRAWER TALL CHEST
ITEM CODE 76372
1

PRE-ASSEMBLY PREPARATION
Before you start:
1.Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the
product
2.Take care when lifting. Product should be assembled as near as possible to the point of
use
3.Ensure that you have all required contents for complete assembly
4.Always read the assembly instructions carefully before beginning assembly.
5.Keep all hardware parts and packaging out of reach of small children.
6.Do not over tighten the screws and bolts as this may damage the threads
2ITEM CODE
Allow 20 min For 2 person Additional tools required
X2

3ITEM CODE

4ITEM CODE
PARTS LIST
1
TOP BOARD
2
SIDE BOARD
3
SIDE BOARD
4
CROSSING BAR
5
CROSSING BAR
6
CROSSING BAR
7
CROSSING BAR
8
BACK BOARD
9
DRAWER SURFACE BOARD
10
DRAWER SIDE BOARD
11
DRAWER SIDE BOARD
12
DRAWER BACK BOARD
13
DRAWER BOTTOM BOARD
14
DRAWER SUPPORT BAR

ITEM CODE
5
STEP:1
M.

ITEM CODE
6
STEP:2

ITEM CODE
7
STEP:3
STEP:4

ITEM CODE
8
STEP:5
STEP:6
L

ITEM CODE9
STEP:7
STEP:8

ITEM CODE
10
STEP:9

ITEM CODE
11
STEP:10

ITEM CODE12
ASSEMBLY IS COMPLETE
STEP:12

13 TEM ICODE
SAFETY BRACKETS INSTRUCTIONS
1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to attach
the Mounting Plate into a stud. If mounting into brick or masonry you will need to
acquire wall anchors.
2. Attach the second Mounting Plate to the furniture frame with the Short Screws.
3. Move the furniture to its final position. Thread a Wall Strap through the both
Mounting Plates and tighten until snug. Do not over tighten.
4. Make sure that the Mounting Plates are firmly attached to the wall and furniture
and that the Wall Strap is snug.
HARDWARE
Mounting Plate x 2 Wall Strap x 1 Large Screw x2 Small Screw x2

14
To protect your furniture, we suggest the following:
•Avoid placing your furniture in direct sunlight.
•Do not place furniture directly under windows.
•Do not place sharp materials (knife, fork, etc.) directly onto your
furniture as sharp material may scrape and damage the finish.
•Do not place material with high temperature directly onto the
surface of your furniture.
•Clean up spills quickly. Water left over a prolonged period of
time may cause damage. Alcohol, perfume, nail polishes,
aftershave and some medication may cause severe finish
damage if not cleaned immediately.
•Use a clean, soft, dry, lint free absorbent cloth to clean your
furniture. Do not use any detergent as they may contain
ingredients that may react and damage the finish.
TEM ICODE
NOTE: If the above care advise is not adhered to your product
warranty may become void