JWA NAXOS 70628 User manual

NAXOS HEIGHT ADJUSTABLE DESK RISER
70628
880mm
400mm
300mm
650mm
120-490mm

2
PRE-ASSEMBLY PREPARATION
Allow 15 min For 1 person Additional tools required
Before you start:
1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product
2. Take care when lifting. Product should be assembled as near as possible to the
point of use
3. Ensure that you have all required contents for complete assembly
4. Always read the assembly instructions carefully before beginning assembly.
5. Keep all hardware parts and packaging out of reach of small children.
6. Do not over tighten the screws and bolts as this may damage the threads
7. Assembly is to be carried out by a competent adult(s) ONLY
8. During assembly, children should be kept away from the product due to possible
risk to injury.
9. Do not use this item if any components are missing or damaged.
10. Please keep the instructions for future reference.

COMPONENTS
D E F
G
CBA
1
Tools required not included
X6 X6X1 X1 X2
X2
1
Warning: Impact Hazard! Moving
Parts can Crush and Cut.
A
When carrying the lift table, be sure to hold the bottom with both
hands. Do not subject the table to a separate force. This can
cause the tabletop to be out of step with the bottom structure.
Flip the desktop,loosen the cable tie.

2
3
B
C
D
G

INSTALLATION
4
E
5

3
6
F
Keep monitor and laptop base fully on the worksurface.
Allowing any part of base or stand to hang off the edge
may result in property damage and or personal injury.
Raise worksurface slowly. Raising worksurface too fast may
create an unstable situation resulting in property damage
and or personal injury.
To avoid the potential to pinch cables it is important to follow the
cable routing instructions in this manual. Failure to follow these
instructions may result in equipment damage or personal injury.
Leave enough slack in cable to allow for full range of vertical
motion (19.3” / 49 cm). Failure to heed this warning may result in
property damage and or personal injury.
DO NOT place hands on or near support bars. Pinch points are
created during lifting and lowering the worksurface. Failure to
follow these instructions may result in serious personal injury.
WARNING
PINCH POINT
7

General Product Care
To protect your furniture, we suggest the following:
Avoid placing your furniture in direct sunlight.
Do not place furniture directly under windows.
Do not place sharp materials (knife, fork, etc.) directly onto your furniture
as sharp material may scrape and damage the finish.
Do not place material with high temperature directly onto the surface of
your furniture.
Clean up spills quickly. Water left over a prolonged period of time may
cause damage. Alcohol, perfume, nail polishes, aftershave and some
medication may cause severe finish damage if not cleaned immediately.
Use a clean, soft, dry, lint free absorbent cloth to clean your furniture.
Do not use any detergent as they may contain ingredients that may react
and damage the finish.
7