Kargo Master 40131 User manual

Installation Guide
40131
Kargo Master
Rancho Cordova, CA 95742
800-343-7486
[e-mail]
DATE: ______________

Instructions –40131
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 1
*PLEASE READ ALL INSTRUCTIONS AND WARNINGS PRIOR TO ASSEMBLING,
INSTALLING, AND USING THIS PRODUCT*
Warning
Always check for wires, fuel tanks and lines, brake lines and other important vehicle
functionality items prior to drilling and installing all products.
Tools Needed
7/16” Socket and Wrench
Phillips Driver
1/4” Drill
Table of Contents
Parts List ..........................................................................................................................................2
Assembly Hardware ........................................................................................................................2
Step 1 –Determine Mount Location ..............................................................................................3
Step 2 –Attach Hard Hat Holder ....................................................................................................4
Before You Begin
•Read all instructions.
•Hard Hat Holder can be installed in a variety of locations. Choose the location that best fits
your needs. These instructions show the holder being mounted on a partition.
•ENSURE LOCATION CHOSEN AND WORK AREA IS CLEAR OF ELECTRICAL AND OTHER
HAZARDS PRIOR TO DRILLING.

Instructions –40131
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 2
Parts
Hardware

Instructions –40131
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 3
Step 1 –Determine Mount Location
•Place Hard Hat Holder in desired location.
•Once the location is chosen, level and square the Hard Hat Holder.
•Mark through the three holes of the Hard Hat Holder onto the sheet metal.
•Remove Hard Hat Holder.
•Drill marked locations using a 1/4" drill bit. ENSURE SAFETY PRIOR TO DRILLING.

Instructions –40131
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 4
Step 2 –Attach Hard Hat Holder
•Place Hard Hat Holder
over previously drilled
holes.
•Attach using 1/4" x 1/2"
pan head screws and
1/4” flanged nyloc nuts.
•Ensure the pan head
screw is orientated as
shown.
Ensure all bolts are tight. Your Installation is now complete.