KBC ESUG4P-PG2-D Series User manual

Introduction
Welcome to KBC Network’s Quick Start Guide for
the ESUG4P-PG , 6 port, PoE switch. This
document provides some quick tips on how to
get up and running. For more detailed
information see the Downloads section below.
Features:
•IEEE80 .3at on 4 ports
•Dual redundant power input
•Alarm output for power supply
•Full & half duplex operation
•MDI/MDI-X
•IP30 casing
Downloads
Installation manual
Other features and functions are described in the
unabridged manual:
http://www.kbcnetworks.com/esug4p-pg -
series/network-products/esug4p-pg -series
Specification sheet:
http://www.kbcnetworks.com/esug4p-pg -
series/network-products/esug4p-pg -series
System Contents
Qty Description
1 Ethernet switch fitted with DIN rail mount.
Wall-mount brackets with screws.
1 Pluggable terminal block.
Equipment Required for Physical
Deployment
You will need a 50 - 57Vdc power supply, these
are supplied separately.
Quick Start
uide
ESU 4P-P 2-D*
Industrial Ethernet Switch
QSG_ESUG4P-PG2-Rev1112 www.kbcnetworks.com
Copyright © KBC Networks td. 2011

Configuring the
ESU
4
P
-
P
2
-
D*
1. Connect the DIN rail or wall-mount
brackets as required.
. Connect a 50 - 57Vdc power supply,
(supplied separately).
3. If using only one power source, connect
pin 1 to pin 5 and pin to pin 6 otherwise
the Power Fail LED will be lit.
4. Install SFP modules as required.
5. Link external devices to the switch with
appropriate cables.
6. Connect the fault alarm contact if required.
LED Status Description
PWR1 ON Power is supplied to the unit
OFF No power to the unit
PWR ON Power is supplied to the unit
OFF No power to the unit
P-Fail ON Power to PWR1 or PWR has
failed
OFF Power is functioning to both or
none of the power inputs.
PoE 1-4 ON The port is supplying power to
the powered device.
OFF There is no powered device
attached or the power
P5 & P6 ON SFP port link established
FLASH Active data flow
OFF No connection to the network
Ethernet RJ45 Port P1 – P4 Status LED
Each RJ45 Ethernet port has two indicators. The lower
green lamp indicates port speed, and the upper green
lamp indicates port link state.
Lower ON Full duplex link
FLASH
Collisions are occurring
OFF Half duplex link or no connection
Upper ON Effective network connection has
been established for the port
FLASH Data traffic is passing through
the port
OFF No effective network connection
has been established for the port
Need Help/Troubleshooting?
Visit our website http://www.kbcnetworks.com or
contact your nearest KBC office or dealer:
APAC:
Phone: [phone]
Email: [e-mail]
EMEA:
Phone: [phone]
Email: [e-mail]
USA:
Phone: [phone]
Toll Free: [phone]
Email: [email protected]
Quick Start uide
ESU 4P-P 2-D*
Industrial Ethernet Switch
ESU 4
P
-
P
2
-
D
*
LED Status Indicators
QSG_ESUG4P-PG2-Rev1112 www.kbcnetworks.com
Copyright © KBC Networks td. 2011