KBC ESUL4-FL1 Series User manual

Introduction
Welcome to KBC Networks’ Quick Start Guide for
the ESUL4- L1, 4 copper port, 1 fiber port
unmanaged switch. This document provides
some quick tips on how to get up and running.
or more detailed information see the Downloads
section below.
Features:
•Low power
•Broad, dual redundant power input
•ull & half duplex operation
•MDI/MDI-X
•IP40 casing
Downloads
Installation manual
Other features and functions are described in the
unabridged manual:
http://www.kbcnetworks.com/esul4-fl1-
switch/network-products/esul4-fl1-series-n
Specification sheets:
http://www.kbcnetworks.com/esul4-fl1-
switch/network-products/esul4-fl1-series-n
Release Notes:
http://www.kbcnetworks.com/specification-
downloads/technical-release-notes
System Contents
Qty Description
1 Ethernet switch fitted with DIN rail mount.
1 24Vdc PSU.
1 Wall-mount brackets with screws.
1 Pluggable terminal block.
Equipment Required for
Deployment
You will need a 24Vdc power supply; this is
supplied with the switch.
Quick Start
Guide
ESU 4-F 1-*2-D*
Industrial Ethernet Switch
QSG-ESUL4-FL1-Rev1208 www.kbcnetworks.com
Copyright © KBC Networ s Ltd. 2012

Configuring the
ESU
4
-
F 1
-
*2
-
D*
1. Connect the DIN rail or wall-mount
brackets as required.
2. Connect the 24Vdc power supply as
follows:
Contact number DC connections AC connections
1 PWR1: + PWR1: L
2 PWR1: - PWR1: N
3 Ground Ground
4 PWR2: - PWR2: L
5 PWR2: + PWR2: N
3. Connect the ground connections as
follows:
4. Link external devices to the switch with
appropriate cables.
LED Status Description
PWR1 ON Power is supplied to the unit
O No power to the unit
PWR2 ON Power is supplied to the unit
O No power to the unit
Fiber Port LED
LED 1
LINK/AC
ON Effective network connection
has been established for the
port
LASH
Data traffic passing through the
port
O No effective network connection
has been established for the
port
Ethernet RJ45 Port Status LED
Each RJ45 Ethernet port has two indicators, a yellow lamp
and a green lamp. The yellow lamp indicates port speed,
and the green lamp indicates port link state.
10/100
(Yellow) ON 100M working status (100Base- TX)
O 10M working status (10 Base-T)
or no connection
LINK/AC
(Green) ON
Effective network connection
has been established for the
port
LASH
Data traffic is passing through
the port
O
No effective network connection
has been established for the
port
Troubleshooting
Visit our website http://www.kbcnetworks.com or
contact your nearest KBC office or dealer:
APAC:
Phone: [phone]
Email: [e-mail]
EMEA:
Phone: [phone]
Email: [e-mail]
USA:
Phone: [phone]
Toll ree: [phone]
Email: [e-mail]
Quick Start Guide
ESU 4-F 1-*2-D*
Industrial Ethernet Switch
ESU
4
-
F 1*2
-
D* ED Status Indicators
QSG-ESUL4-FL1-Rev1208 www. bcnetwor s.com
Copyright © KBC Networ s Ltd. 2012