1. Connect the DIN rail or wall-mount
brackets as required.
2. Connect a 48Vdc power supply (supplied
separately).
3. If using only one power source connect
pin 1 to pin 5 and pin 2 to pin 6 otherwise
the Power Fail LED will be lit.
4. Link external devices to the switch with
appropriate cables.
5. Connect the fault alarm contact
LED Status Description
P1 ON Power is supplied to the unit
OFF No power to the unit
P2 ON Power is supplied to the unit
OFF No power to the unit
P-Fail ON Power to input 1 or 2 has failed
OFF Power is functioning to both or
none of the powered devices.
PoE 1-4 ON The port is supplying power to
the powered device
OFF There is no powered device
attached or the power to the
device has failed
Ethernet RJ45 Port Status LED
Each RJ45 Ethernet port has two indicators, a yellow lamp
and a green lamp. The yellow lamp indicates port speed,
and the green lamp indicates port link state.
10/100
Yellow)
ON Full duplex link
FLASH
Collisions are occurring
OFF Half duplex link or no
connection
LINK/ACT
Green)
ON
Effective network connection
has been established for the
port
FLASH
Data traffic is passing through
the port
OFF
No effective network connection
has been established for the
port
Need Help/Troubleshooting?
Visit our website http://www.kbcnetworks.com or
contact your nearest KBC office or dealer:
APAC:
Phone: +65 98463323
EMEA:
Phone: +44(0)1622 618787
USA:
Phone: +1 949-297-4930
Toll Free: +1 888-366-4276
ESUL5P-D*
Industrial Ethernet Switch
QSG_ESUL5P-D-Rev1112 www. bcnetwor s.com
Copyright © KBC Networ s Ltd. 2011
