Kenwood FDP22 User manual

TYPE: FDP22
instructions

English 2 - 7
ÝY
oq -v

1
11
12
10
9
8
13
2
3
4
7
5
6
8
Cleaning

D E
F
G H
A B C
Assembly and Usage – Standard Attachments

JI
L NM
O
Q
Cord Adjustment Storage
R
P
K
Assembly and Usage – Express Serve

MAX (g) (Secs)
20 -30 10 - 20
200 30
150 20 – 30
2cm 300 10/P
1/4 200 P
2-3cm
250 15 - 20
400 60
300ml
+
x3 45 - 60
+
250g 150g 30
250g 10 - 30
x4 +250g 10
MAX (g) (Secs)
750ml 10 - 20
120
750ml 10 - 20
120

Safety
O
Read these instructions carefully and retain for future
reference.
ORemove all packaging and any labels.
OIf the plug or cord is damaged it must, for safety
reasons, be replaced by Kenwood or an authorised
Kenwood repairer in order to avoid a hazard.
ODO NOT touch the sharp blades. The blade and disc
are very sharp, handle with care. Always hold by the
finger grip at the top, away from the cutting edge,
when handling the sharp cutting blades, emptying
the bowl and during cleaning.
O
This appliance is not suitable for processing ice cubes.
OBefore lifting or carrying the appliance by the handle
on the lid, always check that the bowl and lid are securely
locked in place.
OEnsure the cord is fully unwound before using the
appliance.
ODO NOT process hot ingredients.
OBe careful if hot liquid is poured into the food
processor bowl as it can be ejected out of the
appliance due to sudden steaming.
ONever leave the appliance unattended when it is
operating.
ODo not move appliance whilst in operation.
ODo not exceed the maximum capacities stated in the
recommended usage chart.
ODo not operate your appliance for longer than
30 seconds when processing dough without a rest
period. Processing continuously for longer periods
can damage your appliance.
OAlways remove the knife blade before pouring
contents from the bowl.
OKeep hands and utensils out of the processor bowl
whilst connected to the power supply. If food needs
to be pushed down use a suitable utensil such as a
spatula.
OAlways switch off the appliance and disconnect
from the supply if it is left unattended and before
assembling, disassembling or cleaning.
2

3
OCAUTION: Before removing the lid from the bowl
wait until the attachment/blades have completely
stopped.
ONever use your fingers to push food down the feed
tube. Always use the pusher supplied.
O Do not use excessive force to push food down the
feed tube – you could damage your appliance.
ODo not use the lid lock to operate the processor,
always use the on/off speed control.
ODo not operate the processor with the both the
knife blade and disc fitted. Use only one attachment
at a time.
OThis appliance will be damaged and may cause
injury if the interlock mechanism is subjected to
excessive force.
ONever use an unauthorised attachment.
ONever use a damaged appliance. Get it checked or
repaired: see ‘Service and customer care’.
ONever let the power unit, cord or plug get wet.
ODo not let excess cord hang over the edge of a
table or worktop or touch hot surfaces.
OChildren should be supervised to ensure that they
do not play with the appliance.
OThis appliance shall not be used by children. Keep
the appliance and its cord out of reach of children.
OAppliances can be used by persons with reduced
physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given
supervision or instruction concerning use of the
appliance in a safe way and if they understand the
hazards involved.
OOnly use the appliance for its intended domestic
use. Kenwood will not accept any liability if the
appliance is subject to improper use, or failure to
comply with these instructions.
OMisuse of your processor, blender or mill can result
in injury.
Express Serve
O Avoid contact with moving parts. Keep fingers out
of the food outlet opening.
O Do not operate without the slinger plate fitted. If
the slinger plate is not fitted food will clog under

4
the plate and not exit the food outlet, resulting in
damage to your attachment.
O If the food is not exiting the food outlet, switch off
and check that food is not clogging under the disc
and the slinger plate is fitted. Clear any trapped
food before continuing to process.
O Do not run the Express Serve attachment
continuously for longer than 2 minutes. Leave
to cool for 2 minutes in between each 2 minute
operation.
Cleaning (refer to illustration)
O Always switch off and unplug before cleaning.
O Wipe the power unit with a damp cloth, then dry.
Ensure that the interlock area is clear of food debris.
O Do not immerse the power unit in water.
O Handle the blade and cutting discs with care - they
are extremely sharp.
Before plugging in
OMake sure your electricity supply is the same as the one shown on the underside of your
appliance.
Important – Plug and Fuse Information
O The wires in the cord are coloured as follows:
Blue = Neutral
Brown = Live
O If the plug supplied with your appliance has a fuse fitted and the fuse fails it must be
replaced with one of the same rating.
O If the plug or cord requires replacing a new cord set should be fitted by an Authorised
Kenwood Repairer.
Note:
O For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse.
If the fuse cover is lost then the plug must not be used until a replacement can be
obtained. The correct fuse cover is identified by colour and a replacement may be
obtained from your Kenwood Authorised Repairer (see Service).
O If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An electric
shock hazard may arise if an unwanted non-rewireable plug is inadvertently inserted
into a socket outlet.
O This appliance conforms to EC Regulation 1935/2004 on materials and articles intended
to come into contact with food.
Before using for the first time
1 Remove the plastic blade covers
from the knife blade. Take care
the blades are very sharp. These
covers should be discarded as they
are to protect the blade during
manufacture and transit only.
2 Wash the parts see ‘Cleaning’.
3 Ensure the cord is fully unwound
before using the appliance.

5
Key
1Pusher
2Feed tube
3Lid
4Knife blade
5Bowl
6Power unit
7Cord clip
8Grating/slicing disc
9Lid handle
10 On/off switch + Pulse
Express Serve (if supplied)
11 Slinger plate
12 Food outlet
13 Express Serve Bowl
To Use Your Food
Processor
Main bowl
Refer to Illustrations A- H
Important
O Your processor is not suitable for
crushing or grinding coffee beans,
or converting granulated sugar to
caster sugar.
O When adding almond essence or
flavouring to mixtures avoid contact
with the plastic as this may result in
permanent marking.
Hints & tips
O Use the pulse (P) for short bursts.
The pulse will operate for as long as
the control is held in position.
O Some foods may discolour the
plastic. This is perfectly normal and
will not harm the plastic or affect
the flavour of your food. Rub with
a cloth dipped in vegetable oil to
remove the discolouration.
Knife Blade
O Bread Dough - Place the dry
ingredients in the bowl first and
then add the liquid. Process until
a smooth elastic ball of dough is
formed.
O Use the handle on the lid to support
if the appliance starts to move on
the worktop.
O For coarser textures use the pulse
control.
O Take care not to over-process.
O When making pastry use fat straight
from the fridge cut into 2cm cubes.
Prune Marinade
300g Honey, 50g Prunes and 50ml
Water.
Store in fridge overnight.
Process for 4 seconds using Pulse
Express Serve/Disc
Refer to Illustrations I- P
O Use fresh ingredients
O Do not cut food too small. Fill the
width of the feed tube fairly full.
This prevents the food from slipping
sideways during processing.
O There will always be a small amount
of unprocessed food on the disc or
in the bowl after processing.
Cord Adjustment
Refer to Illustration Q
O Wrap the cord around the base of
the processor to the desired length
and clip the cord together using the
cord clip.
Storage R
After use the knife blade and disc can
be stored together in the bowl.
Do not operate the processor, with both
the knife blade and disc fitted. Use only
one attachment at a time.