Kimo MP130 User manual

MP130 manometer with sealing kit
for gas network

ON : Switch-on
OFF : Switch-off
Escape : Return to previous screen
1x : ''Hold'' : measure holding
2x : ''Min/Max'' : display of minimum and
maximum values from channel 1 since last
request
3x : Back to held measure
''Function'' key
''On / off'' key
''Select'' key
See table
'' unctions available from main screen''
1x Level 1
2x Level 2
3x No backlight
''Backlight'' screen
''OK'' key
1x ''To validate''
or ''Self-calib ation'' see below
Key description of MP130 manometer
Functions available from main screen
Select pressure unit Press to scroll down unit.
1x
Automatic shut-off Press to scroll down minutes.
2x
Beep Press to activate or deactivate
3x
Self-calibration 1x Start self-calibration countdown*
Validate with
Validate with
Validate with
*Self-calibration is performed by disconnecting the two pressure inlets of the sensor, then by pressing AutoZ key.

● Connect the cone adapter (the most suitable to the transversal section of the tube) to the male connector of the
sealing kit, and the female connector to the positive inlet of the manometer, as below :
● Isoler l'installation : fermer le robinet du compteur et bloquer les connecteurs fournis à l'installation
Gas meter
ilter and
throttle
● Connect the cone adapter to the connector downstream the counter.
● Switch-on the manometer.
● Inject air or gas to test the installation at the good pressure :
- when feeding with air, pressurize the system with the supplied pump ; once the desired pressure is reached, close
the tap.
- when using combustible or inert gases, close the tap and pressurize the system.
Checking point for new,
renovated and under use
installations
Positive inlet of the manometer
Preliminary operations to use the MP130 manometer with its sealing kit
● Isolate the installation : close the tap of the counter and block the supplied connectors to the installation.
MP 130
Pump
Cone adapter

NTang – MP130 – 29/03/10– RCS (24) Périgueux 349 282 095 Non-contractual document – We reserve the right to modify the characteristics of our products without prior notice.