Kingfisher KI 2400 Series User manual

Revision 6 Date: 20/4/2017
QUICK REFERENCE GUIDE
KI2400/KI2800 Series Light Source

Revision 6 Date: 20/4/2017
Quick Reference Guide –KI2400/KI2800 Light Source
KI2400/KI2800 HAND HELD FIBER SOURCE,
Manual operation
•To remove interchangeable connector adaptor, press button
on front of case and pull off adaptor. This may be easier with
a test lead attached.
•To turn on press [On/Off].
•To view firmware version, hold [F4] then press [On/Off].
•To view all display segments, press and hold[On/Off], [F1]
at the same time until it stops beeping.
•To defeat auto power-off,hold [On/Off] for 3 seconds at turn
on until ‘Perm’ is displayed.
•Low battery is indicated with a battery symbol.
•To enter Source menu, press [Source].
•To return to Home menu, press [Home].
•To turn on back light press [ Backlight].
Source Menu:
•Press [ - ] or [ + ] to select operating wavelength.
•To change power level, press [F2] then use [ - ] or [ + ] (laser
light source only, not available for LED sources).
•To restore default power level, press [F2] then press
[Toggle centre] (laser light source only, not available for LED
sources).
•To select modulation while source is on, press and
release [Mode]. Press [Mode] again to select next
available frequency or ID-tone. Alternatively, press and
hold [Mode] then use [ - ] or [ + ] to cycle through all
options.
•To end modulation, press and hold [Mode] then press
[Toggle centre]. Alternatively, press and hold [Mode] for
3 sec.
Autotest Operation
•To start Autotest press keys below on light source;
For light sources with up to 4 :Press [AUTOTEST].
For light source with 5 or more :
- press [Auto] to start Autotest for the default
wavelength group (possibly “singlemode”).
- hold [-] then press [Auto] to initiate Autotest for the
other wavelength group (possibly “multimode”).
•To check wavelength status, e.g. if it is selected for
limited wavelength AutoTest, press [F4] while source is
on.
•To toggle selection of wavelengths for limited
wavelength AutoTest, press and hold [Toggle centre]
then press [F4] while source is on.
•To start limited wavelength AutoTest, press and hold
[Toggle centre], then press [Auto].

QUICK REFERENCE GUIDE: LIGHT SOURCE
Change Records:
Rev
Date
Editor
Change description
6
20/4/2017
TO Ng
Added instruction to view full
segment of display & to view
FW version (under 3 under
Manual Operation section).