Kleenmaid CH40S User manual

COOKTOP
c o l l e c t i o n
Instructions for Use
and Warranty Details
Solid Hotplate Cooktops CH40S - 600 mm Stainless Steel
CH41W - 600 mm White
CH42B - 600 mm Black

Congratulations on the purchase of your
new Kleenmaid appliance.This appliance
has been designed and manufactured to
give you years of reliable performance.
For best results, carefully read the
instructions on how to install your new appliance. Correct
installation will avoid delays and unnecessary service calls.
Once installation is complete, read this booklet and get to
know the controls and the features of your new appliance.
If you need further information call our
Customer Care Centre
1300 652 100
We reserve the right to alter the specifications with no
influence on the operation of the appliance. This instruction
manual cannot be reason for claim.

CONTENTS
General description . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Use of controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Use of pans . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Connections sheamtic . . . . . . . . . . . . . . . . . . . . . . . . . 7
Wiring diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Warranty and service . . . . . . . . . . . . . . . . . . . . . . . . . 9
1
WARNING
MAKE
MAX
POWER - (W)
TYPE
TENSION
a) Repair of any fault in your hob must be carried out only by an
Authorized Repair Service, otherwise the guarantee is not valid.
b) The technical details and identification of the appliance are shown on
the specifition plate.
c) Consult his plate before procceding with electrical connection.
d) Electrical connection must be carried out by a specialist familiar with
the laws and official regulations governing such while they are not
covered by a pan.
Fill in the data table in the manual with all the data of the cooker that
appear on its label.

2
USE OF CONTROLS
Make sure that you operate the
right control for the burner you
wish to use
1
ELECTRICAL PLATES
Electrical plates have 6 positions giving
different heat outputs. Table 1, gives a
guide to these outputs.
To operate it, you may turn the control
to the left or to the right, as you wish.
GENERAL DESCRIPTION
USE O4 ELECTRIC HOTPLATE
TYPE: EI-4E
1,5kW
1,5kW
2kW
2kW

USE OF PANS
3
135 W 165 W
1500W.p Hot
2000W.p Hot 175 W 220 W
250 W 500 W
300 W 850 W
750 W 1500 W
1150 W 2000 W
TABLE 1
012345 6
OFF LOW
Keep warm
Prepare
delicate sauces
and cremes
MEDIUM
Boil and roast
white meats,
fish or
puddings.
Boil potatoes,
pulses, soups
Prepare
sauces
HIGH
Boil and roast red
meats, minced meat,
omelettes.
Fry potatoes, fish,
pasta.
Boil relatively large
quantities of water
MINIMUM MÁXIMUM
Make sure that the diametre of the
pan is equal to or bigger than the
plate you are going to use.
The plate should not be lit without a
pan.
The base of the pan should be flat
and dry.
ELECTRICAL PLATES

4
IMPORTANT: First of all, switch off the equipment.
CLEANING
If your top is stainless steel, there are
adequate products available in shops that
you may use. Once it is clean, rinse the top
with water and a soft cloth.
If the top is enamelled, use soapy water to
clean it. Never use abrasive products or
pads. Immediately remove all stains of
vinegar, lemon and acids spillage in
general.
Clean electric plates immediately with water
and soap. Then, heat the plate slightly and rub
it with mewspaper.

5
INSTALLATION
Before the installation, please
check all measures of the
equipment and fit-in housing.
Cut out a piece of the worktop
following the instructions.
Equipment type “X” for fire
protection grade.
NOTE:
The worktop must be provided
with a shelf “A” so that the top
cannot be reached from inside,
due to the temperatures it
reaches.
Such shelf will be located once
the top has been fixed in the
worktop.
Place the hob face down on a
table, and after removing the
backing paper, affix the sealing
gasket all around the hob.
A: operating table
B: joint
C: Bottom cover
NOTE: DO NOT SILICONE SEAL THIS APPLIANCE TO THE WORK SURFACE.
150 Máx.

6
INSTALLATION
Then, place the hob in the cavity
in the woktop. Press down tightly
so that sealing joint is perfectly
closed.
Fix the 4 clamps underneath the
hob to the corresponding 4
corners of the cavity. (Clamps
and nuts are supplied in the
accessory bag).

7
CONNECTIONS SCHEAMTIC
The hot plate is supplied with a power cable
(N2GMH2G types) prepared for 220...240V AC.
If the type of connections to which the hotplate is to be installed is other than
220 to 240 V Ac rmove the cable and make the connection according to the
adjacent drawings. (The cable must support temperatures of up to 120ºC).
The hotplate must be connected to the mains with a plug that meets the EEC
7 publication or with a multi-pole with a distance between the open contacts
of a least 3 mm.
This device conforms to European directives 73/23/Cee and 89/336/CEE
Total power
Hotplate: 60 cms., 6,3kW
PLATE
60 cms 27,5 A 32 A220...240V~ 14 A 16 A220...240V~
Three phase ∆
Voltage Tensión
Protection
Int.nominal
by phases Protección
Int.nominal
por fases
PLATE
60 cms 11 A 12 A380...400V~ 16 A 20 A380...400V~
Three phase ∆
Voltage Voltage
Protection
Int.nominal
by phases Protection
Int.nominal
by phases

8
WIRING DIAGRAM
1 - Hot Plate 1500W 2 - Hot Plate 2000W 3 - Hot Plate 1500W 4 - Hot Plate 2000W 5 - Switch 6 - Switch 7 - Switch 8 - Switch 9 - Neon
10 - Main Block COLOURS T-R = Red AZ = Blue V-A = Green-Yelow M = Brown B = White N = Black