Knight Active25 User manual

knightgroup.co.nz
Desk Hung - Assembly Instructions
Tools Required:
Active25
Two People Tools

Page 1
Assembly Instructions
knightgroup.co.nz
Step 1
Page 1
Assembly Instructions
Step 3Step 2
Step 1a
Locate the guide holes in lower section of the Active25
screen face. Lay the screen down on a flat surface with
guide holes facing upwards. Fix clamp brackets to the
screen with supplied wood screws - do not over tighten
(use a low torque setting - less than 10).
Allow for 1-2 people to support the screen while you
attach it to the worktop. Guide the clamp brackets onto
worktop so worktop sits between the top of the clamp
bracket and the clamp plate. Tighten grub screws to
secure the brackets to the worktop.
To clamp over a 75mm metal frame and worktop
align Aon the centre holes of Bwith the lip of A
furthest away from the lip of B. Insert grub screws from
underneath of lip A. Keep clamp plate Caside ready for
install on worktop.
Assemble clamp brackets (ACT25CLAMP) based
on the thickness of the worktop. To suit a 25mm
worktop align Aon the centre holes of Bwith the lip
of Aclosest to the lip of B. Insert grub screws from
underneath of lip A. Keep clamp plate Caside ready
for install on worktop.
Active25 Desk Hung
A
C
C
A
B B
C