KoamTac KDC180 User manual

KDC180
Charging Cradle Mini Guide
Charging via Type-C Port (2-Slot) Charging via DC Connector (10-Slot)
1x KDC180 2-Slot Cradle with No-Boot Spacer
1x KDC180 2-Slot Cradle with UHF Spacer (Optional)
1x 5V/2.4A USB Adaptor
1x USB TYPE-C Cable
What’s in the Box? 2-Slot Cradle
1x KDC180 10-Slot Cradle with No-Boot Spacer
1x KDC180 10-Slot Cradle with UHF Spacer (Optional)
1x 12V/10A DC Power Adaptor
What’s in the Box? 10-Slot Cradle
12V/10A
ADAPTOR
With UHF Spacer
(Optional)
With No-Boot Spacer
With No Boot Spacer
With UHF Spacer (Optional)
* The shape of the adaptor may vary by country.
Connect the power adaptor to the DC jack on the back of
the 10-Slot Charging Cradle (B). Place the KDC180
into the charging cradle to begin charging.
Connect the USB adaptor and USB Type C cable. Then,
connect the USB Type C cable to the USB Type C port on
the back of the 2-Slot Charging Cradle (A). Place the KDC180
into the charging cradle to begin charging.

Cradle Power LED Status
Battery LED Status
Main Power
Status LED
Green: Always on when the cradle is powered on
Orange: Charging
Green: Fully charged
Battery
Status LED
For all models other than the KDC180 with UHF, charge the
KDC180 by placing it into the cradle as shown below: (C)
Charging UHF Models (Optional)
Charging with a Protective Boot
Make sure the UHF spacer is installed and then place the
KDC180 UHF model into the cradle as shown below: (F)
1. Remove the No-Boot spacer from the cradle by pulling
the tab on the back of the spacer up. (D)
2. KDC180 devices other than UHF models can now be
charged while wearing a protective boot. To charge, place
the KDC180 into the cradle as shown below: (E)
UHF Spacer
How to Charge Your KDC180
* KDC180W model with optional Inductive charging antenna
can be charged on both Qi compliant wireless charging pad
and charging cradle.
Tilt the battery as shown in the figure and mount it
in the battery slot. (G)
1010mAh Battery Charging
G