Kodak i4200 User manual

See the User’s Guide for feed module replacement
procedures.e
To order supplies, contact your reseller, or go to
http://scannerstore.kodak.com
Part numbers must be ordered from Parts Services.
In the United States call:1-800-431-7278
IMPORTANT:
The Roller Cleaning Pad contains sodium lauryl ether
sulfate which can cause eye irritation. Refer to the
MSDS for more information.
Staticide Wipes contain isopropanol which can cause
eye irritation and dry skin. Wash your hands with soap
and water after performing maintenance procedures.
Refer to the Material Safety Data Sheet (MSDS) for
more information (www.kodak.com/go/MSDS).
EASTMAN KODAK COMPANY
343 State Street
Rochester, NY 14650 U.S.A.
A-61656 / Part #6J7238 January, 2010
© Eastman Kodak Company, 2010
TM: Kodak
i4000 Series Scanners
Reference Guide
Replace pre-separation pad
Replace separation roller
Pre-separation Pad
Separation Roller
Supplies and Accessories
CAT No. Description
832 7538 Feeder Consumables Kit
838 7938 Extra-Large Feeder Consumables Kit
146 2415 Extra-Extra-Large Feeder Consumables Kit
834 8054 Image Guide Set (without Printer)
871 4438 Image Guide Set (with Printer)
808 8239 Flippable Background (without Printer)
800 0853 Flippable Background (with Printer)
896 5519 Staticide Wipes for Kodak Scanners
169 0783 Transport Cleaning Sheets
853 5981 Roller Cleaning Pads
840 5425 Printer Ink Blotters
818 3386 Enhanced Printer Black Cartridge
159 6832 Enhanced Printer Red Cartridge
CAT No. Accessories
844 5280 Feeder Kit for Ultralightweight Paper
809 6943 Enhanced Printer Accessory
Part No. Accessories
5E4754 66.04 cm (26 in.) document extender
9E3216 76.2 cm (30 in.) document extender
9E5277 86.36 cm (34 in.) document extender
Kodak Service & Support
www.kodak.com/go/disupport
1.800.822.1414
(US&C only; all other regions, contact your local
Kodak Support Center)
When contacting support, have the following available:
•A description of your problem
•Scanner model and serial number
•Computer configuration
•Software application you are using

Codes
Code LED Explanation
U1 Red Check the imaging guides
U2 Red Ink cartridge missing
U3 Red Increase document length setting
U4 Future use
U5 Red Timeout: USB disconnected
while scanner was running, etc.
U6 Red Scanner cover open
U7 Red • Too much paper is in the input
elevator
• The feed module is not inserted
properly
U8 Red Multifeed stop
U8 Green flash Multifeed pause
U9 Red Document jam or the paper path
is blocked
ERed flash • Be sure all cables are
connected properly
• Turn power off and then on
again
If problem persists, call Service.
Cleaning Frequency Chart
Procedure Start of
day Middle of Shift
Start of
new
shift
1Vacuum output tray and input areas (input
elevator and transport)
x
2Clean all rollers;
including feed module xx
3Run transport cleaning
sheet xx
4Clean imaging guides:
basic xxx
Clean imaging guides:
thorough (see User’s Guide)xx
Cleaning the transport and rollers Running a cleaning sheet and cleaning
the imaging guides
For detailed cleaning and replacement procedures see Chapter 5, Maintenance in the User’s Guide.