Kogan KAHTP20BLKWA User manual

2000W Black Glass Portable Electric Panel Heater with WiFi
KAHTP20BLKWA
Quick Start Gui e
Table of Contents
Safety & Warnings.......................................................................................................................................................... 1
Overview........................................................................................................................................................................... 2
Installation........................................................................................................................................................................ 2
Operation.......................................................................................................................................................................... 3
Cleaning & Care.............................................................................................................................................................. 5
Safety & Warnings
Handle with care and inspect reg larly to ens re prod ct is in good working order.
If this prod ct, power s pply cord or pl g shows any signs of damage: stop se, npl g
the prod ct and contact Kogan.com s pport.
•Read all instr ctions before sing the appliance and retain for reference.
•This appliance is not intended for se by persons (incl ding children) with red ced
physical, sensory or mental capabilities, or lack of experience and knowledge, nless they
have been given s pervision or instr ction concerning se of the appliance by a person
responsible for their safety.
•This appliance is designed for indoor se: follow directions and se only as described.
•Do not allow the power cord to be exposed to water, heat, direct s nlight or overhang
where it can be p lled or otherwise be damaged or pose a hazard.
•This appliance contains no ser-serviceable parts. If it experiences any fail re or damage,
contact Kogan S pport.
•Ens re the appliance is switched o before connecting to the mains power s pply.
•The heater m st not be located immediately below its power socket.
•Do not operate in areas where f el, paint or any other flammable liq ids are sed or
stored.
•In order to avoid overheating, do not cover the heater or block the air intakes or exha st
vents in any manner. Do not place the heater on carpet and don’t place the cable nder
carpets.
•Do not to ch the hot s rfaces directly.
•Do not insert or allow foreign objects to enter into any ventilation or exha st openings, as
this may ca se electric shock, fire or damage to the appliance.
•Always ens re that yo r hands are dry before operating or adj sting any switches on the
prod ct, or to ching the pl g and socket-o tlet.
•Do not leave the heater nattended when it’s in se.
•The most common ca se of overheating is deposits of d st or fl  in the appliance.
Ens re these deposits are removed reg larly by disconnecting the appliance from the
power s pply, then vac m cleaning the air vents and grilles.
1

Overview
Control Panel Functions
1. Display
2. Temperat re “+” b tton
3. Temperat re “-”b tton
4. Power b tton
5. Mode b tton
6. Timer b tton
7. Receiver
8. Child lock b tton
Installation
Portable Installation
Attach the feet on the heater’s ho sing, and fix them with the s pplied 8x ST12x4mm screws.
Wall Mounting
Install the bracket with screws as per Image 1 below.
Drill holes at each sides on the wall and insert the plastic expanded pl gs. Attach the bracket to
the wall with screws as per Image 2.
Place the heater in a s itable position, ens ing that the holes align with the bracket (Image 3).
Tighten the screws on the top of bracket to sec re it as per Image 4.
2
Note: The f nctions on the control panel
correspond to the remote

Operation
Power Function
Press “ ” to set f nctions. The pper part of the display will show the room temperat re. The
heater will be working at low power heating conditions.
Mo e
Press “ ” to switch between low or high temperat re power.
Temperature selection
Press "+" or "-" to select the desired temperat re from a range of 15-35°C. The temperat re
indicator will remain lit for a short time.
Timer
Press the timer b tton “ ” to select the desired range between 1 ho r to 24 ho rs. The display
will show the remaining time.
Chil Lock
Press the child lock b tton for 3 seconds and “ ” will be displayed on the screen. Until yo press
the child lock b tton for 3 seconds again, the only command which will work is power.
Wi-Fi Function & SmarterHome Integration
1. Download the “Kogan Smarter Home” app from the Play Store or App Store.
2. Select yo r co ntry code, phone n mber and tap “Get” to get a message containing
verification code.
3. Enter the verification code in the message and tap “Login” to log into the app.
4. Open the app and tap “ADD DEVICES” or select the + b tton in the top right corner.
5. Yo r heater will enter pairing mode a tomatically when t rned on. If it is not, then yo
can power it o and on again or press and hold the mode b tton (“ ”) for 5 seconds or
longer to reset it.
3

6. Select Wi-Fi network (NOTE: it m st be a 2.4Ghz network), enter password and tap
“Confirm”.
When it has been added, yo can press the “Edit” pencil icon to change its name.
Yo can also change its name in the control panel nder “Devices”.
7. After the device is connected, tap “Devices” at the bottom. The device name will appear
in the list. Tap it to enter the control panel.
NOTE: When the device is oine, there will be an “oine” indicator in the devices list. If
the device is shared by others, there will be a do ble loop indicator.
1. Press “ ” (On/O) to t rn the heater on or o.
2. Press “ ” (Mode) to choose between high or low power modes.
3. Press “ ” to activate Child Lock and prevent heater b ttons from being mishandled.
4. Press “ ” to set when to t rn on/o settings.
5. Press “-” and “+ ” to adj st the temperat re the heater will heat to. The c rrent
temperat re is displayed nderneath with the “C rrent temp” indicator.
By selecting the men in the top right, yo will see additional options s ch as
renaming, seeing device info, feedback, checking for pdates as well as creating a
gro p and sharing.
8. Create Gro p: Select m ltiple of the same device and a “Gro p” will appear in the Devices
list. The controls for this gro p are identical (see above). Any control made to the gro p
will take eect on all devices in that gro p.
4

9. Sharing: Share device with other sers sing a connected phone n mber. The sers can
control the device with their own acco nts.
10. Manage personal information in “My profile”.
1. Personal information, incl ding acco nt name and phone n mber
2. Information abo t shared devices
3. Message centre
4. Feedback
5. F.A.Q.
6. Connected phone n mber
7. Abo t
11. Scenes: Create scenarios to carry o t a tomated tasks, e.g. t rn the heater on when the
temperat re drops below 5°C. Choose one of the fo r pre-set tasks or create yo r own
with the + b tton.
Cleaning & Care
•Before cleaning, always remove the pl g from the electrical o tlet.
•Clean the air inlet and o tlet grilles freq ently.
•Never se abrasive powders or solvents.
User man al is s bject to change witho t notice. For the latest version of yo r ser man al, please visit
https://www.kogan.com/ serman als/
5