Kogan KALRGFLMHTA User manual

1800W FLAME EFFECT
HEATER
KALRGFLMHTA & KASMLFLMHTA

• Read all instructions before using the appliance and retain this user guide for reference.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
• This appliance is not suitable for outdoor use.
• Do not allow the power cord to be exposed to water, heat, direct sunlight or overhang
where it can be pulled or otherwise be damaged or pose a hazard.
• Do not insert any objects, metal or otherwise, into the heater or outlet.
• Do not spray pesticide or any flammable spray near the heater.
• Do not use the heater near a shower, bath or swimming pool.
• This appliance contains no user-serviceable parts. If it suffers any failure or damage,
cease usage and contact help.Kogan.com for support after consulting the
Troubleshooting section of this guide.
SAFETY & WARNINGS
WARNING: Do not cover the heater, as it may overheat.
CAUTION: Some parts of this product can become very hot and
cause burns.

*KASMLFLMHTA model shown.
1
Outer box
4
Feet
2
Internal packaging
5
Main unit
3
Screws
6
Internal packaging
OVERVIEW

Front View
Rear View
Switches
*KALRGFLMHTA model shown.

1. Remove the heater from the packaging with foam still attached and gently place
it on a desktop or table.
2. Remove the stand legs and attach them with the supplied screws.
3. Place the heater upright once the legs have been installed.
ASSEMBLY
(1)
(2)
(3)

Connect the power cord to a power outlet and turn on the main switch.
Switches
1. High heat switch
2. Low heat switch
3. Turn the flame effect on/off
Auto shutoff
A cut-off switch is fitted to the heating element to prevent damage due to overheating. If it
cuts-off due to an obstruction in the airflow, the heater must be allowed to cool for 15
minutes and the obstruction must be removed before restarting.
OPERATION
(3)
(2)
(1)

If you experience any issues with the appliance:
• Inspect the appliance and its power cord/plug for any signs of physical damage.
• Unplug and wait 10-15 minutes for any residual charge to leave the product and then try
using the product again.
• Check that the thermostat on the device is set above the current room temperature.
If your issue is still not resolved, cease use and contact help.Kogan.com for support.
TROUBLESHOOTING

NOTES

Need more information?
We hope that this user guide has given you
the assistance needed for a simple set-up.
For the most up-to-date guide for your product,
as well as any additional assistance you may require,
head online to help.kogan.com