Kogan FreeSync KAMN24FLSB User manual

24" FULL HD FREESYNC 75HZ
FRAMELESS MONITOR
(1920 x 1080)
KAMN24FLSB

•Read all instructions before using the appliance and retain for reference.
•Unplug the monitor before cleaning it.
•Use a clean, slightly dampened cloth to wipe the main monitor body.
•To clean the screen: turn it OFF, unplug it and wait for it to cool completely, then
wipe it with a dry micro-fibre cloth.
•Do not use cleaning alcohol, ammonia-based liquids or other harsh cleaners.
•This monitor is designed with ventilation holes on the back of the casing. Do not
cover or block them.
•Do not insert any object or spray any liquid into the vents.
•Avoid placing the monitor near heaters, stoves, fireplaces or other sources of heat,
as well as in rooms lacking adequate ventilation.
•Do not position the monitor in unsafe locations. If the monitor falls, it may be
damaged and may injure nearby people.
•Unplug the monitor if it is not going to be used for an extended period.
•Do not place heavy objects on the monitor, its power cord or any connected cable.
•Do not open the back panel of the monitor, as it contains a high-voltage current
even when not plugged in.
The terms HDMI and HDMI High-Definition Multimedia Interface
and the HDMI Logos are trademarks or registered trademarks of
HDMI Licensing Administrator, Inc. in the United States and other
countries.
SAFETY & WARNINGS

Monitor
Stand connector
Stand base
Screws (x2)
VESA screws (x4)
HDMI cable
Power cable
User guide
COMPONENTS

Monitor Controls
1
Menu button
Press to display the OSD menu or enter sub-menus.
2
Down button
Press to move down in the menu.
3
Up button
Press to move up in the menu.
4
Exit button
Press to exit.
5
Power button
Press to turn the monitor on/off.
Monitor Ports
6
Power connector
7
Audio In
8
VGA connector
9
HDMI connector
OVERVIEW

Attention: Panel is fragile. Keep the foam underneath the monitor while assembling
the stand.
1. Carefully remove the monitor from the packaging with foam attached and place it
face down on a soft cloth spread across a stable surface such as a table.
2. Remove and assemble the stand base and connector.
STAND ASSEMBLY

3. Remove the connection block from the back of the monitor by pressing the detach
button.
4. Insert the Connection Block into the back of the monitor, then push down until it
snaps into place.
5. Remove the bottom foam and place the monitor on the desk or other location
intended for use: installation is complete.
Connection Block
Close Open

1. Carefully remove the monitor from the packaging with foam attached and place it
face down on a soft cloth spread across a stable surface such as a table.
2. Remove the connection block from the back of the monitor by pressing the detach
button. If the stand is attached, remove it.
3. Remove the original screws ( ) from the opening in the back of the monitor.
4. Follow the directions with your mount, stand or accessory and install the monitor
on the wall or future as desired, using the included 4 screws when mounting the
monitor. Refer to the image ( ) for correct screw placement.
VESA MOUNT
Stand stem
Stand base
Monitor
Foam
Stand plate
Button
Mount (Not included)

Power Cable
Connect the included power cable to the monitor power port and then connect the other
end to a power outlet.
Audio In
Connect an audio cable to the 3.5mm audio port on the monitor (Audio In) and the 3.5mm
audio port on your computer.
CONNECTIVITY
Power cable

HDMI
Connect an HDMI cable from the computer’s display output to the monitor’s display input.
VGA
Connect a VGA cable from the computer’s display output to the monitor’s display input.
HDMI cable (Included)
HDMI Output
PC
VGA cable (Not Included)
VGA Output