Installation and Care Guide
K-78202X-L, K-78282X
ขอแนะนําการติดตั้งและการดูแลรักษา
©2018 Kohler Co.
1307566-X2-A
(1905 mm) To Floor
Prepare the Site/ 1
3
5
2
3" (76 mm)
Dimmer
Switch
Swinging Panels
3" (76 mm)
Min
3" (76 mm)
Slide two clips onto the T-slot. Ensure the cabinet is
centered as desired. Drill pilot holes.
6
If needed, insert anchors into the wall. Secure the clips
with round-headed long screws.
7
Slide two clips onto the bottom T-slot. Drill pilot holes
and secure with round-headed long screws.
Fix the cabinet on the mounting bar.
Insert top clip from the center of the top.
Slide the hanger hooks onto the top T-slot as shown.
4
Lift the cabinet onto the mounting bar. Ensure the
hooks engage the bar.
3/32"
51 mm
3/32"
IMPORTANT NOTICE TO INSTALLERS!: Please leave these instructions
for the consumer. They contain important information.
Please take a few minutes to review this manual before you start installation.
If you encounter any installation or performance problems, please don’t
hesitate to contact us.
All information in this manual is based upon the latest product information
available at the time of publication. At Kohler, we constantly strive to improve
the quality of our products. We reserve the right to make changes in product
characteristics, packaging or availability at any time without notice.
• Before installation carefully inspect the new fixture for any signs of damage.
• This cabinet is designed for either right or left door swing. Check the wall
cavity for obstructions.
Grounding Instructions
• This product should be grounded. This product is equipped with a cord
having a grounding wire.
• This repair or replacement of the cord is necessary, do not connect the
grounding wire to either flat blade terminal. The wire with insulation having
an outer surface that is green with or without yellow stripes is the grounding
wire.
• Check with a qualified electrician or service personnel if the grounding
instructions are not completely understood, or if in doubt as to whether the
product is properly grounded.
• This product is factory equipped with a specific electric cord. If the product
must be reconnected for use on a different type of electric circuit, the
connection should be made by qualified service personnel.
•
•
•
•
•
•
Before You Begin/
WARNING: Risk of product damage. Use anchors (not provided) rated
for the loaded weight of this product. Refer to the anchor manufacturer's
instructions.
WARNING: Risk of electric shock. Disconnect power before servicing.
Mark the mounting bar position (centered as desired) on the wall. Drill holes and insert anchors if needed. Using a
level to ensure that the mounting bar is level.
Install mounting bar with screws kit.
51 mm
