Kohler 1031338 Manual

1034576-9-B 1 © 2005 Kohler Co.
NOTE: The faucet illustrated may look different than your actual
product. These instructions apply to all products that use this kit.
Remove the housing setscrew from the back of the faucet
housing using a 2.5 mm hex wrench.
Use a 2.5 mm hex wrench to remove the handle screw.
Remove the handle.
Remove the Old Handle
CAUTION: Risk of personal injury. Scalding may result if the
limit stop is not reinstalled properly.
NOTE: The water temperature does not need to be adjusted if the
water temperature is below 105∞F (41∞C).
NOTE: Use a thermometer rated for 120∞F (49∞C) or greater.
NOTE: When using a tempered water supply, install the
vandal-resistant plug button.
Optional Temperature Limiting Adjustment
SERVICE KIT INSTRUCTIONS
Handle Kit
1031338
1047233
Handle
Limit
Stop
Handle
Screw
Housing
Setscrew

1034576-9-B 2 © 2005 Kohler Co.
Limit Stop
Handle
Cleaning
Strap
Screw Setscrew
Right Tab
Stop
Plug Button
Tab Edge
Adjust the Water Temperature Limit ó Handle Installations
Turn on the water and adjust to the full hot position by turning
the handle toward the back of the faucet until it stops.
Determine the temperature using a thermometer. If the
temperature exceeds 105∞F (41∞C), complete the following steps.
Turn the handle until vertical.
Attach the cleaning strap over the sensor.
Remove the handle screw using the supplied 2.5 mm hex wrench.
Remove the handle and the limit stop.
Remove the limit stop from the handle splines.
Rotate and reposition the limit stop on the handle splines.
Rotating the limit stop clockwise toward the back of the faucet will
decrease the maximum temperature limit. Each spline represents
approximately 10∞F (5∞C) change in temperature.
Reinstall the handle vertically with the limit stop in place. Do
not secure the handle with the screw at this time.
Turn the handle to full hot and check the water temperature.
Repeat the above procedures until the desired temperature is
reached.
Secure the handle assembly with the screw.
Remove the cleaning strap and turn on the water.
Adjust the Water Temperature Limit ñ Vandal Resistant Installations
NOTE: If you install the vandal-resistant plug button, save the limit
stop and handle to adjust the water temperature at a later date.
Using the handle, adjust the water to the desired temperature.
Remove the handle screw using the supplied 2.5 mm hex wrench.
Press the vandal-resistant plug button and firmly into place.