Kohler 77980T-4 User manual

1293309-2A-A 1
BEFORE YOU BEGIN
HANDLE OPERATION
ROUGH-IN DIMENSIONS
77980T-4 Wall-Mount Single Control Lavatory Handle-Lever
77980T-4A Wall-Mount Single Control Lavatory Handle-Pin
All information is based on the latest product information available at the time of publication. Kohler Co. reserves
the right to make changes in product characteristics, packaging, or availability at any time without notice.
Please leave these instructions for the consumer. They contain important information.
NOTES:
1. Flush the water supply pipes thoroughly to remove debris.
2. Inspect the supply tubing for damage. Replace as necessary.
3. Observe local plumbing codes.
4. These products should match with wall-mount single control handle lavatory faucet valve 28138T.
5. Install the valve 28138T before installing these handles.
INSTALLATION INSTRUCTIONS
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could
adversely affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
COMPONENTS
17
Ø42
8
71
6
Ø60
77980T-4
Ø5
91
8
6
77980T-4A
Ø42
Ø60
Lift the handle gently, turn clockwise for hot water, counter-clockwise for cold water.

1293309-2A-A 2
SERVICE PARTS
INSTALLATION
3025573**
833730
1249005
1293304**
1330501**
871310 3026062
As figure 1 shown, remove and discard the protector(1) after completing the finished wall. Turn off the valve.
As figure 2 shown, install the stem adapter(2) into the handle(3). Pre-install the screw(4) from the screw hole in
the bottom. Slide the escutcheon(5) onto the sleeve.
Install the handle to the valve stem. Make sure its lever is vertical downwards. Tighten the screw with hex
wrench(6). NOTE: Do not excessively tighten the screw.
The figure 3 shows the correct position of the handle in the closed position.
**Color code must be specified when ordering.
NOTE: For all Asia pacific regions (excluding China) add SP (SPxxxxxxx**) in front of the part number when ordering.
1
2
3
6
4
5
① ② ③