Kolpin 21515 User manual

Rev. 02
21515 - Rhino Grip XL – Double
M
MM
Mounting Instructions
ounting Instructionsounting Instructions
ounting Instructions -
--
-
1. Position the Rhino Grip mounting base on the rack of the ATV where desired.
. Run the ¼” bolts provided through the main base and through the metal backer plate. Secure with nylon
nuts. Repeat three more times.
3. Tighten the (4) truss head bolts evenly. Note: Be sure not to over tighten the bolts, as too much torque
can over stress the base and cause the grip to fail.
4. Place the connector into the doubler plate.
No. Description QTY. pare P/N
1 Plastic Mounting Base 2
2 Doubler Plate 2 71503
3 Connector 2
4 Metal Backer Plate 2 71513
5 Rhino Grip 4 71511
6 Adjustment Knob 4 71501
7 Kwik Clip - mall 4
No. Description QTY. pare P/N
8 Kwik Clip - Large 2
9 Rubber trap 4 87010
10 ¼” – 20 x 1.50” Truss Bolt 8
11 ¼” – 20 Nylon Nut 8
12 Kolpin Logo 6
13 M6 – Black Nylon Nut 2
14 M6 Flat Head Machine crew 2
5
2
8
1
These grips are designed to
quickly and easily mount to the
rear rack of an ATV. Note:
Hardware provided is based on
the biggest tube diameter. You
are required to cut the excess
threads from the grip once
installed. Failure to do so may
result in damage to your
machine.
To tilt the grip simply
loosen the adjustment
knob, tilt the grip to
the angle of your
choice, and retighten.
9
3
2

Rev. 02
5. Place the M6 black nylon locking nut into the bottom of the connector, so that the nylon part of the nut
is facing out towards you.
6. Take the flat head machine screw and tipping the doubler plate so that the connector is facing upwards;
start twisting the machine screw until it engages the nut in the connector. Tighten securely.
7. Place the extra Kolpin logos over the flat head screw.
8. Insert the doubler plate assembly into the mounting base, already attached to ATV, and position as
desired.
9. Secure the double plate assembly to the mounting base using the Kwik clip provided.
10. Insert the Rhino Grips in the desired position on the doubler plate and secure using the Kwik Clips
provided. NOTE: Grip can rotate 360° to accommodate any angle, and the grip can tilt 0° to 180° at 45°
increments.
11. Repeat on opposite side of vehicle.
Kolpin Outdoors, Inc.
205 N. Depot Street, Fox Lake, WI 53933
Phone #: (877) 9KOLPIN or [phone]
www.kolpinpowersports.com customerserv[email protected]