Kolpin Rhino Grip XL Double 21515 User manual

Rev. 03
21515 - Rhino Grip XL –Double
Mounting Instructions -
1. Position the Rhino Grip mounting bases with a metal backer plate on the rack of the ATV where desired.
2. Run the ¼” truss head bolts provided through the main base/metal backer on the rear rack. Place a
second metal backer plate under the rack tube and secure with nylon nuts.
3. Tighten the (4) truss head bolts evenly. Note: Be sure not to over tighten the bolts, as too much torque
can over stress the base and cause the grip to fail.
4. Place the connector into the doubler plate.
No.
Description
QTY.
Spare P/N
1
Plastic Mounting Base
2
71541
2
Doubler Plate
2
71503A
3
Connector
2
71516
4
Metal Backer Plate
4
71513
5
Rhino Grip
4
71511
6
Adjustment Knob
4
71501
7
Kwik Clip - Small
4
71509
No.
Description
QTY.
Spare P/N
8
Kwik Clip - Large
2
71540
9
Rubber Strap
4
87010
10
¼” – 20 x 1.50” Truss Bolt
8
11
¼” – 20 Nylon Nut
8
12
Kolpin Logo
6
13
M6 –Black Nylon Nut
2
14
M6 Flat Head Machine Screw
2
5
2
8
1
These grips are designed to
quickly and easily mount to the
rear rack of an ATV. Note:
Hardware provided is based on
the biggest tube diameter. You
may want to cut the excess
threads from the grip fir safety
and to prevent damage to your
machine.
To tilt the grip simply
loosen the adjustment
knob, tilt the grip to the
angle of your choice, and
retighten. NOTE: Lighter
objects ONLY can be
carried in the Full-Tilt
position.
9
3
2

Rev. 03
5. Place the M6 black nylon locking nut into the bottom of the connector, so that the nylon part of the nut
is facing out towards you.
6. Take the flat head machine screw and tipping the doubler plate so that the connector is facing upwards;
start twisting the machine screw until it engages the nut in the connector. Tighten securely.
7. Place the 2 supplied Kolpin emblems over the flat head screw.
8. Insert the doubler plate assembly into the mounting base, already attached to ATV, and position as
desired.
9. Secure the double plate assembly to the mounting base using the Kwik clip provided.
10. Insert the Rhino Grips in the desired position on the doubler plate and secure using the Kwik Clips
provided. NOTE: Grip can rotate 360° to accommodate any angle, and the grip can tilt 0° to 180° at 45°
increments.
NOTE: The Rhino Grip XL Double can be used for many light-duty applications. DO NOT force objects into the
grip as over stressing component parts can cause damage that is not immediately noticed. For a custom fit,
the grips can be trimmed with a sharp knife. Balancing the weight in each grip is also important for safe
operation. For the Ultimate protection in transporting firearms, we recommend using our Ratcheting Rhino
Grips or any of our Patented Kolpin Gun Boots and brackets.
Kolpin Outdoors, Inc.
205 N. Depot Street, Fox Lake, WI 53933
Phone #: (877) 9KOLPIN or [phone]
www.kolpinpowersports.com customerservi[email protected]