Konica Minolta bizhub 200 User manual

43 Speers Rd. Winnipeg, MB, R2J 1M2
P: 204.953.0540 | F: 204.953.0549
Konica Minolta Bizhub 200/250/350
Page 1
Enter/Change SMTP Settings
Get the IP address
First, we need to get the IP address of the machine. If you already know this, you can skip to the next section.
1. On the machine, press [Utility/Counter]
2. Touch [Printer Setting]
3. Touch [Test Print]
4. Touch [Check Job Details]
5. The configuration page will print out
6. Press the yellow RESET button
The IP address is located under the TCP/IP section of the configuration page
Enable SMTP Authentication
In order to send an email, the machine must be able to log-in. Therefore, we need to enable SMTP authentication, as by
default it is disabled. (NOTE: Be careful editing this setting. Changing the wrong Mode or Bit may damage the machine)
1. On the machine, press [Utility/Counter]
2. Touch [Admin Settings], enter the password (12345678 OR
00000000) and touch [enter]
3. Touch [Admin 2] and then touch [Software SW]
a. Select [Mode Selection]
i. Enter 380
b. Select [Bit Selection]
i. Enter 01000100
4. Touch [Enter]
5. Press the Yellow RESET button

43 Speers Rd. Winnipeg, MB, R2J 1M2
P: 204.953.0540 | F: 204.953.0549
Konica Minolta Bizhub 200/250/350
Page 2
Access the webpage
Now we need to access the Bizhub’s webpage and change the SMTP information
1. Open up your web browser (Internet Explorer, FireFox, Opera, Safari etc.) and enter the IP address into the
address bar
2. In the top left corner of the screen, where it says “Administrator
Password”, enter the admin password (default: 12345678 OR 00000000)
and click log-in
3. Click the Network tab
4. On the left hand side, click E-Mail/Internet Fax
5. Click SMTP
6. Enter the SMTP information
7. Click Apply
8. Click Log-Out