Kontron ADA-ETX-CD-FC4 User manual

If it’s embedded, it’s Kontron.
ADA-ETX-CD-FC4 / ADA-SDVOB-FC5
Document Revision 111

www.kontron.com
» Table of Contents «
1User Information............................................................................ 1
1.1 About This Document ...............................................................................................................1
1.2 Copyright Notice .....................................................................................................................1
1.3 Trademarks ............................................................................................................................1
1.4 Standards..............................................................................................................................1
1.5 Warranty ...............................................................................................................................2
1.6 Technical Support ...................................................................................................................2
2Introduction ................................................................................. 3
2.1 ADA-SDVOB-FC5......................................................................................................................3
3Specification ................................................................................. 4
3.1 Functional Specification ...........................................................................................................4
3.1.1 ADA-ETX-CD-FC4 (96006-0000-00-4)..........................................................................................4
3.1.2 ADA-SDVOB-FC5 (96006-0000-00-5) ..........................................................................................4
3.2 Block Diagram ........................................................................................................................6
3.2.1 ADA-ETX-CD-FC4 (96006-0000-00-4)..........................................................................................6
3.2.2 ADA-SDVOB-FC5 (96006-0000-00-5) ..........................................................................................6
3.3 Mechanical Specification ..........................................................................................................7
3.4 Electical Specification ..............................................................................................................7
3.5 Environmental Specification ......................................................................................................7
4ADA-SDVOB-FC5 Connectors.............................................................. 9
4.1 Connector Locations ................................................................................................................9
4.2 Pinout List ........................................................................................................................... 10
5Schematics ..................................................................................12
5.1 Feature connector ................................................................................................................. 12
5.2 Regulator ............................................................................................................................ 13
5.3 SDVOB to DVI........................................................................................................................ 14

www.kontron.com
5.4 SDOVC to DVI........................................................................................................................ 15
5.5 DVIB connector..................................................................................................................... 17
5.6 DVIC connector ..................................................................................................................... 18
6Appendix C: Document Revision History..............................................19

ADA-ETX-CD-FC4 / ADA-SDVOB-FC5 / User Information
1
1User Information
1.1 About This Document
This document provides information about products from Kontron Embedded Modules GmbH and/or its subsidiaries.
No warranty of suitability, purpose, or fitness is implied. While every attempt has been made to ensure that the
information in this document is accurate, the information contained within is supplied “as-is” and is subject to
change without notice.
For the circuits, descriptions and tables indicated, Kontron assumes no responsibility as far as patents or other rights
of third parties are concerned.
1.2 Copyright Notice
Copyright © 2003-2010 Kontron Embedded Modules GmbH
All rights reserved. No part of this document may be reproduced, transmitted, transcribed, stored in a retrieval
system, or translated into any language or computer language, in any form or by any means (electronic, mechanical,
photocopying, recording, or otherwise), without the express written permission of Kontron Embedded Modules
GmbH.
DIMM-PC®, PISA®, ETX®, ETXexpress®, microETXexpress™, X-board®, DIMM-IO® and DIMM-BUS® are trademarks or
registered trademarks of Kontron Embedded Modules GmbH. Kontron is trademark or registered trademark of Kontron
AG.
1.3 Trademarks
The following lists the trademarks of components used in this board.
»IBM, XT, AT, PS/2 and Personal System/2 are trademarks of International Business Machines Corp.
»Microsoft is a registered trademark of Microsoft Corp.
»Intel is a registered trademark of Intel Corp.
»All other products and trademarks mentioned in this manual are trademarks of their respective owners.
1.4 Standards
Kontron Embedded Modules GmbH is certified to ISO 9000 standards.

ADA-ETX-CD-FC4 / ADA-SDVOB-FC5 / User Information
2
1.5 Warranty
This Kontron Embedded Modules GmbH product is warranted against defects in material and workmanship for the
warranty period from the date of shipment. During the warranty period, Kontron Embedded Modules GmbH will at its
discretion decide to repair or replace defective products.
Within the warranty period, the repair of products is free of charge as long as warranty conditions are observed.
The warranty does not apply to defects resulting from improper or inadequate maintenance or handling by the buyer,
unauthorized modification or misuse, operation outside of the product’s environmental specifications or improper
installation or maintenance.
Kontron Embedded Modules GmbH will not be responsible for any defects or damages to other products not supplied
by Kontron Embedded Modules GmbH that are caused by a faulty Kontron Embedded Modules GmbH product.
1.6 Technical Support
Technicians and engineers from Kontron Embedded Modules GmbH and/or its subsidiaries are available for technical
support. We are committed to making our product easy to use and will help you use our products in your systems.
Please consult our Web site at http://www.kontron.com/support for the latest product documentation, utilities,
drivers and support contacts. Consult our customer section http://emdcustomersection.kontron.com for the latest
BIOS downloads, Product Change Notifications and additional tools and software. In any case you can always contact
your board supplier for technical support.

ADA-ETX-CD-FC4 / ADA-SDVOB-FC5 / Introduction
3
2Introduction
2.1 ADA-SDVOB-FC5
The ADA-SDVOB-FC5 (96006-0000-00-5) is a small board to convert the signals from single channel SDVO to DVI.
The SDVO signals are available on Kontron’s ETX® boards which have implemented the "SDVO feature connector" like
ETX®-CD and ETX®-DC.
The device is available also as ADA-ETX-CD-FC4(96006-0000-00-4) which offers two SDVO to DVI channels and is
only supported by ETX®-CD.

ADA-ETX-CD-FC4 / ADA-SDVOB-FC5 / Specification
4
3Specification
3.1 Functional Specification
3.1.1 ADA-ETX-CD-FC4 (96006-0000-00-4)
SDVOB - DVI Transmitter: Chrontel CH7307C
SDVOC - DVI Transmitter: Silicon Image SIL1362
»Digital Visual Interfach (DVI) Transmitter up to 165M pixels/second
»Supports resolutions up to UXGA (1600x1200)
»DVI low jitter PLL
»DVI hot plug detection
3.1.2 ADA-SDVOB-FC5 (96006-0000-00-5)
SDVOB - DVI Transmitter: Chrontel CH7307C
»Digital Visual Interfach (DVI) Transmitter up to 165M pixels/second
»Supports resolutions up to UXGA (1600x1200)
»DVI low jitter PLL
»DVI hot plug detection

ADA-ETX-CD-FC4 / ADA-SDVOB-FC5 / Specification
5
SDVO Output during bootup
The Bios must be set to enable the SDVO output during boot-up.
»ETX®-DC in AMI Bios Setup: Chipset Display Control: SDVO or CRT + SDVO
»ETX®-CD in the Phoenix Bios Setup: Devices Integrated Video Display Control: EFP only or CRT + EFP

ADA-ETX-CD-FC4 / ADA-SDVOB-FC5 / Specification
6
SDVO Output during bootup
The regarding driver must enable the interface. This does not need an enabled boot up display set to SDVO. It can
happen that you have an enabled SDVO boot device, but when in windows the driver is loaded, the SDVO interface is
disabled after the graphic driver installation.
You can enable it in blind mode by pressing the default driver hotkey combination <CRTL><ALT><F4>.
3.2 Block Diagram
3.2.1 ADA-ETX-CD-FC4 (96006-0000-00-4)
ADA-ETX-CD-FC4
3.2.2 ADA-SDVOB-FC5 (96006-0000-00-5)

ADA-ETX-CD-FC4 / ADA-SDVOB-FC5 / Specification
7
3.3 Mechanical Specification
3.4 Electical Specification
Supply Voltage
»5V DC+/- 5%
Supply Voltage Ripple
»Maximum 100 mV peak to peak 0 –20 MHz
3.5 Environmental Specification
Temperature
»Maximum operating temperature: 0 to +60 °C (**)
»Non operating: -30 to +85 °C
Note: **The maximum operating temperature is the maximum measurable temperature on any spot on a module’s
surface. You must maintain the temperature according to the above specification.

ADA-ETX-CD-FC4 / ADA-SDVOB-FC5 / Specification
8
Humidity
»Operating: 10% to 90% (non condensing)
»Non operating: 5% to 95% (non condensing)

ADA-ETX-CD-FC4 / ADA-SDVOB-FC5 / ADA-SDVOB-FC5 Connectors
9
4ADA-SDVOB-FC5 Connectors
4.1 Connector Locations

ADA-ETX-CD-FC4 / ADA-SDVOB-FC5 / ADA-SDVOB-FC5 Connectors
10
4.2 Pinout List
Feature Connector J1 Pinout
Pin
Pin on ETX®-CD
Description
1
Reserved
nc
2
Reserved
nc
3
VCC
5V power
4
VCC
5V power
5
VCC
5V power
6
RESET#
Reset signal
7
SDVO_CTRLDATA
I2C based control signal for SDVO devices; data
8
SDVO_CTRCLK
I2C based control signal for SDVO devices; clock
9
GND1
Ground
10
SDVO_TVCLKINP
TV Clock Input positive
11
SDVO_TVCLKINN
TV Clock Input negative
12
GND2
Ground
13
SDVO_FLDSTALLP
Field Stall positive
14
SDVO_FLDSTALLN
Field Stall negative
15
GND3
Ground
16
SDVOB_REDP
Channel B; Red positive
17
SDVOB_REDN
Channel B; Red negative
18
GND4
Ground
19
SDVOB_BLUEP
Channel B; Blue positive
20
SDVOB_BLUEN
Channel B; Blue negative
21
GND5
Ground
22
SDVOC_REDP
Channel C; Red positive
23
SDVOC_REDN
Channel C; Red negative
24
GND6
Ground
25
SDVOC_BLUEP
Channel C; Blue positive
26
SDVOC_BLUEN
Channel C; Blue negative
27
GND7
Ground
28
SDVOB_INTP
Channel B; Interrupt positive
29
SDVOB_INTN
Channel B; Interrupt negative
30
GND8
Ground
31
SDVOC_INTP
Channel C; Interrupt positive
32
SDVOC_INTN
Channel C; Interrupt negative
33
GND9
Ground
34
SDVOB_GREENP
Channel B; Green positive
35
SDVOB_GREENN
Channel B; Green negative
36
GND10
Ground
37
SDVOB_CLKP
Channel B; Clock positive
38
SDVOB_CLKN
Channel B; Clock negative
39
GND11
Ground
40
SDVOC_GREENP
Channel C; Green positive
41
SDVOC_GREENN
Channel C; Green negative
42
GND12
Ground
43
SDVOC_CLKP
Channel C; Clock positive
44
SDVOC_CLKN
Channel C; Clock negative
45
GND13
Ground

ADA-ETX-CD-FC4 / ADA-SDVOB-FC5 / ADA-SDVOB-FC5 Connectors
11
DVI Connector J2/J3 Pinout
Pin
Name
Pin
Name
1
TMDS Data2-
13
Not connected
2
TMDS Data2+
14
+5 V Power
3
GND
15
GND
4
Not connected
16
Hot Plug Detect
5
Not connected
17
TMDS Data0-
6
DDC Clock [SCL]
18
TMDSData0+
7
DDC Data [SDA]
19
GND
8
Not connected
20
Not connected
9
TMDS Data1-
21
Not connected
10
TMDS Data1+
22
GND
11
GND
23
TMDS Clock +
12
Not connected
24
TMDS Clock -
C1
Not connected
C2
Not connected
C3
Not connected
C4
Not connected
C5
GND
Legend:
DDC = Display Data Channel
T.M.D.S. = Transition Minimized Differential Signal
Please refer to following link for detailed information about DVI specification: http://www.ddwg.org
Note1: On VCC pins: To protect the external powerlines of peripheral devices the customer has to take care about:
that the wires have the right diameter to withstand the maximum available current that the enclosure of the
peripheral device fulfits the fire protecting requirements of IEC/EN 60950
Note2: Analog signals on both DVI-I connectors are not supported
Warning: Please use only the provided flat foil cable or ensure that the used cable is the same type as the provided
one.

ADA-ETX-CD-FC4 / ADA-SDVOB-FC5 / Schematics
12
5Schematics
5.1 Feature connector

ADA-ETX-CD-FC4 / ADA-SDVOB-FC5 / Schematics
13
5.2 Regulator

ADA-ETX-CD-FC4 / ADA-SDVOB-FC5 / Schematics
14
5.3 SDVOB to DVI

ADA-ETX-CD-FC4 / ADA-SDVOB-FC5 / Schematics
15
5.4 SDOVC to DVI

ADA-ETX-CD-FC4 / ADA-SDVOB-FC5 / Schematics
16

ADA-ETX-CD-FC4 / ADA-SDVOB-FC5 / Schematics
17
5.5 DVIB connector