Kozyard Brenda Swing Chair User manual

Assembly Manual
Brenda swing chair
Kozyard LLC Products

BEFORE ASSEMBLING,MAKE SURE THAT YOU LAY OUT AND IDENTIFY ALL PARTS LISTED
BELOW IN THE PARTS LIST. INSTALL ON LEVEL GROUND.
INSTALL NOT LESS THAN 6 FEET FROM ANY OBSTRUCTION SUCH AS FENCE, GARAGE,HOUSE,
OVERHANGING BRANCHES, LAUNDRY LINES,OR ELECTRICAL WIRES.
TIGHTEN ALL NUTS AND BOLTS SECURELY.ALL BOLTS SHOULD BE HAND TIGHENED
BEFORE USE.NEVER USE POWER TOOLS OR EXCESSIVE FORCE DURING ASSEMBLY AND
TIGHTENING OF BOLTS.
IT IS RECOMMENDED TO BE AT LEAST 2 PEOPLE FORE A SAFE ASSEMBLY OF THE PRODUCT.
ASEEMBLY INSTUCTION
TOOL REQUIRED:
ALLEN WRENCH SMALL WRENCH
2 PERSON
ASSEMBLY
(PROVIDED)

I
1
E
1
H
BC
I
E
A
PR
UXY
G
F
OQ
Z
AA BB
D
S
V
1
K
LM N
M8X32
1
M6X30 M6X40 M8X70
6X
m6x80
PARTS LIST
LEG TUBE LEG TUBE top cross bar
top cross bar leg cross bar hanging pipe
back leg cross
bar
back leg cross
bar bar spring hook
armrest armrest canopy
1X
seat frame back frame

Step-1
Step-2
2
Use bolt R to connect part D and C to build the beam.
Use bolt S to connect Part A and B, then connect with the beam.
Attention: Both part A should be the same side, and both Part B should be in the
other side.
Use bolt P to connect Part E and Part A & B.
P
V
V
V

Step-3
Step-4
3
O
U
Use bolt O to connect Part G and Part F to build a connection tube for the rear foot.
Use bolt U to connect the rear foot tube with part B.
V
V

Step-5
Step-6
4
m
l
S
N
Q
Use bolt S to connect Part E1
and I with Part M.
Use bolt Q connect Part I with Part L
Use bolt B to connect
E1 with I
V
V
V
Loose the part M(back) screws first,then connect part L(seat) together
by the screws.

Step-7
Step-8
5
K
Use part H to hook the seat to the frame
Use Part Y to fix the canopy to the ends of the beam

Step-9
6
Tight all of the screws.

Kozyar
A
Mer W
rd.com
www.kozyard.com
Toll-fr