Kramer DSP-1 User manual

DSP
-1 Quick Start (P/N: 2900-300909QS REV 3)
P/N:
2900- 300909QS
Rev:
3
Scan for full manual
DSP-1 Quick Start Guide
This guide helps you install and use your DSP-1 for the first time.
Go to www.kramerav.com/downloads/DSP-1 to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
DSP-1 Digital Sound Processor 4 Rubber feet 1 Bracket set
1 Power adapter and cord 1 Quick start guide
Step 2: Get to know your DSP-1
#
Feature
Function
1
IN 1 LED
Lights green when a signal is present on IN 1.
2 IN 2 LED Lights green when a signal is present on IN 2.
3 ON LED Lights green when the device is powered.
4
IN 1 3.5mm Mini Jack
Connect to an unbalanced stereo audio input.
5
IN 2 5-pin Terminal Block Connector
Connect to a balanced stereo audio input.
6 LINE OUT 5-pin Terminal Block Connector Connect to a balanced stereo audio output.
7 FACTORY DEFAULT Recessed Button Press and hold while powering the device to reset IP settings to
factory default values.
8
RS-232 (G, Rx, Tx) 3-pin Terminal Block Connector
Connect to a PC or a serial controller.
9
ETHERNET RJ-45 Port
Connect to the Ethernet.
10 5V DC 5V DC connector for powering the unit.
Step 3: Install DSP-1
Install DSP-1 using one of the following methods:
•Attach the rubber feet and place the unit on a flat surface.
•Fasten a bracket (included) on each side of the unit and attach it to a flat surface. For more information go to
www.kramerav.com/downloads/DSP-1.
•Mount the unit in a rack using an optional RK-3T rack adapter.

Step 4: Connect the inputs and outputs
Always switch OFF the power on each device before connecting it to your DSP-1. For best results, we recommend that you always
use Kramer high-performance cables to connect AV equipment to DSP-1.
Step 5: Connect the power
Connect the 5V DC power adapter to DSP-1 and plug it into the mains electricity.
Safety Instructions
Caution:
There are no operator serviceable parts inside the unit
Warning:
Use only the Kramer Electronics power supply that is provided with the unit
Warning:
Disconnect the power and unplug the unit from the wall before installing
See www.KramerAV.com for updated safety information.
Step 6: Operate DSP-1 via the embedded Web pages
RS-232
Protocol 3000
Baud Rate:
115,200
Stop Bits:
1
Data Bits:
8
Parity:
None
Change the volume of input 2 to -10 DB
#X-AUD-LVL 1,2,-10
TCP/IP Parameters
IP Address:
192.168.1.39
Maximum UDP Connections:
Unlimited
UDP Port #:
50000
Subnet mask:
255.255.000.000
Maximum TCP Connections:
Unlimited
TCP Port #:
5000
Default gateway:
192.168.0.1
Default Username / Password:
Admin / Admin
Full Factory Reset
Protocol 3000
Excluding ETH: use “#FACTORY” command and use “#RESET” to restore the factory default values.